User manual CATEYE CC-8000

[. . . ] If the icon now flashes, this indicates that the computer and sensor are too far apart or that the battery is low. ] Is the clearance between the sensor and magnet too great?Does the magnet pass through the sensor zone?Adjust the positions of the magnet and sensor. Is the computer installed at the correct angle? [. . . ] Is the distance between the computer and sensor too great?Install the sensor closer to the computer. In cold weather, battery performance degrades. (All Clear a ). Standard Parts #169-6590 Parts Kit ENG #169-6580 Speed Sensor A Wireless Sensor The sensor was designed to receive signals within a limited range to prevent sensor signal interference. Thus, the sensor and computer must be relatively close. If the temperature or battery power is low, they may need to be even closer than normal. The sensor must be installed at the top of the fork, and the distance between the sensor and the computer should not exceed approximately 70 cm. Install the computer on the stem, with its bottom surface facing the sensor. (Take into account the angle of the stem. ) Interference may occur, resulting in malfunction, if the computer is: · Near a TV, PC, radio, motor, or in a car or train. · Close to a railroad crossing, railway tracks, TV stations and or radar base. * The specifications and design are subject to change without notice. E Battery Case Cover #169-9690 Hi-Power Wheel Magnet Starting/Stopping measurement This computer automatically starts measurement when the bicycle is moving. Switching Mode symbol . . . . . . . . . . . . . . . . . . . . . . b Press the MODE button to cycle through different functions, which are listed in the OPERATION FLOW chart. Resetting data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . b As shown in the OPERATION FLOW, press the MODE button to clear data when RESET appears on the screen. The trip distance cannot be reset. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by CatEye Co. , Ltd. May void the user's authority to operate the equipment. Power-saving function If the computer has not received a signal for 10 minutes, power-saving mode will activate and only the clock will be displayed. When the computer receives a sensor signal again, the measuring screen reappears. If the unit remains inactive for two weeks, the unit enters SLEEP mode. Press the MODE button to stop SLEEP mode. LIMITED WARRANTY - 2-Year Computer/Sensor only Setting the clock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] c With the symbol displayed, press the SET button to set the clock. Press the MODE button to move time forward. The value changes more rapidly if the button is pressed and held. Press the SET button to move from the "hour" to "minutes" digit. [. . . ]