User manual CATEYE CC-RD300W

[. . . ] Over-tightening can damage the bracket threads. When cleaning the computer, bracket and sensor, do not use thinners, benzene, or alcohol. Dispose of used batteries according to local regulations. LCD screen may be distorted when viewed through polarized sunglass lenses. 1 Bracket band 2 Bracket 3 Speed sensor 4 Magnet 5 Sensor rubber pad 6 Bracket rubber pad 7 Nylon ties (x2) Install the sensor and magnet A The distance between the computer and the sensor must not exceed the transmission range of 70 cm. [. . . ] (The speed is not displayed. ) (Spin the front wheel, bringing the computer closer to the sensor. If the icon now flashes, this indicates that the computer and sensor are too far apart or that the battery is low. ) Is the clearance between the sensor and magnet too great?(must be 5 mm) Does the magnet pass through the sensor zone?Adjust the positions of the magnet and sensor. Is the computer installed at the correct angle?Back of computer must face toward the sensor. Are the computer and sensor too far apart?(The distance must not exceed 70 cm. ) Install the sensor closer to the computer. In winter, battery performance diminishes. In the case of the computer, after replacing the battery, re-start the computer according to the "Preparing the computer", above. Then reinitialize the computer referring to "Preparing the computer". Reinitialize the computer referring to "Preparing the computer". Tm Elapsed Time 0:00'00" - 9:59'59" Pace arrow Indicates whether the current speed is faster ( ) or slower ( ) than the average speed. Dst Trip Distance 0. 00 - 999. 99 km [mile] Current speed 0. 0(4. 0) - 105. 9 km [0. 0(3. 0) - 65. 9 mph] Dst2 Trip Distance-2 0. 00 - 999. 99 / 1000. 0 - 9999. 9 km [mile] Selected Mode Starting/Stopping measurement Measurements occur automatically when the bicycle is in use. During measurement, or flashes. Av Average Speed*2 0. 0 - 105. 9 km/h [0. 0 - 65. 9 mph] MODE *1 Switching computer function Pressing MODE switches function, in order, as shown on the left. Mx Maximum Speed 0. 0(4. 0) - 105. 9 km/h [0. 0(3. 0) - 65. 9 mph] Resetting data To reset measurement data, display any data other than for Dst-2 and then press and hold MODE. Pressing and holding MODE with Dst-2 displayed resets Dst-2 only. The total distance is never reset. Odo Total Distance 0. 0 - 9999. 9 / 10000 - 99999 km [mile] Specification Battery . . . . . . . . . . . . . . . . . Computer : Lithium battery (CR2032) x 1 Sensor : Lithium battery (CR2032) x 1 Battery life . . . . . . . . . . . 1 years (If the computer is used for 1 hour/day; the battery life will vary depending on the conditions of use. ) Sensor : Unit Total Distance reaches about 10, 000 km (6, 250 mile) * This is the average figure of being used under 20 °C temperature and the distance between the computer and the sensor is 65 cm. Controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-bite, 1-chip microcomputer (Crystal controlled oscillator) Display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Liquid crystal display Sensor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No contact magnetic sensor Wheel circumference range . . . . . 0100 mm - 3999 mm (Default figure A: 2096 mm, B: 2096 mm) Working temperature . . . . . . . . . . . . . . . [. . . ] This does not affect your statutory rights. CO. , LTD. 2-8-25, Kuwazu, Higashi Sumiyoshi-ku, Osaka 546-0041 Japan Attn: CATEYE Customer Service Section Service & Research Address for USA CATEYE Service and Research Center 1705 14th St. 115 Boulder, CO 80302 Phone: 303. 443. 4595 Toll Free: 800. 5CATEYE Fax: 303. 473. 0006 E-mail: service@cateye. com URL: http://www. cateye. com Setting * After changing, be sure to press MENU to register the change (by setting. pressing & * If the menu screen is not touched for a minute, the MODE holding) Measuring screen reappears without data changes. Wheel selection . . . . . [. . . ]