User manual CATEYE HL-EL830RC

[. . . ] To remove unit after use, pull it out while pressing the button on the bracket. CAUTION!: Make sure the light unit is cool to the touch before removing it. · Attaching/removing the switch Attach the switch to the handlebar as shown. CAUTION!: Mount the switch unit where it does not interfere with the handling of the bicycle. [. . . ] NOTE: When the battery indication becomes red, charge the batteries as soon as possible. Guigeline for the battery indicator 5 Green : More than 50% left Yellow : 50 to 20% left Red : Less than 20%. * The battery indicator is only an estimation of the remaining battery run-time, and varies with the environment or conditions of use. C Charging Indicator To AC Power Outlet C How to Charge Battery unit Important! · If the battery unit is wet, wipe dry with a dry cloth before charging the batteries. · Be sure to use only the supplied battery charger. · If the charging indicator flashes green, there is a short somewhere in the circuit. Unplug the charger and remove the cause. · If the charging indicator turns green a few minutes after charging begins or if the indicator continues a fast green flashing, stop charging, unplug the charger from the outlet, and do steps 1 and 2. If the same result occurs repeatedly, the batteries may be deteriorated. · The standard charging time and run time are guideline values and depend on the operating environment. · If the battery unit repeatedly does not meet the proper run time even though it is fully charged, it might be at the end of its operating life. Replace the old battery unit with a new one. The used battery unit should be disposed of properly according to local regulations. Plug the battery charger to an AC outlet. NOTE: Check that the charging indicator flashes red three times as the power lamp turns red. Connect the plug of the battery charger to the plug of the battery unit. NOTE: · Charge the batteries with the plug locked. · When charging is complete, the indicator light changes from flashing red to green. After charging is complete, make sure to unplug the charger from the AC outlet. Ring 4 LOCK 2 SPECIFICATIONS Light source ----------------------------------Battery unit -----------------------------------Battery charger ------------------------------Operating time -------------------------------Three High-Power White LEDs Rechargeable lithium-ion battery/7. 4V, 4600mAh CHR-2300/4600mAh Li-ion (AC100V-240V 50/60Hz) Approx. 5 hours (in the case of Low) Standard charging time ---------------------- Approx. 5 hours Temperature range --------------------------- Charging: 41°F ­ 104°F(5°C ­ 40°C) Operating: 5°F ­ 113°F (-15°C ­ 45°C) Recharge/discharge number of times ----- About 300 times (until the rated capacity drops to 70%) * The specifications and design are subject to change without notice. Charging indicator state Standard charging time Approx. 5 hours SPARE PARTS #534-1856 #534-1857 Red light / Blinking green light : Charge error Red light / Red light : Charging Red light / Green light : Charging is completed #534-1856 #534-1857 Light unit Battery unit (lithium-ion batteries 4600mAh) #534-1858 Battery unit (lithium-ion batteries 2300mAh) #533-8827 H34 Bracket UL:#037-5895 / UK:#037-5896 / EC:#037-5897 / AS:#037-5899 Lithium-ion battery charger #534-1860 Battery fixing strap CAUTION!: Use only genuine spare parts from CATEYE. FOR SAFE OPERATION · Never short-circuit the terminals of the battery unit or the battery charger. It may cause the unit to overheat, resulting in fire or damage to the component. · The battery unit uses lithium batteries. [. . . ] Service must be performed by CatEye or an authorized retailer. To return the product, pack it carefully and enclose the warranty certificate (proof or purchase) with instruction for repair. Please write or type your name and address clearly on the warranty certificate. Insurance, handling and transportation charges to CatEye shall be borne by person desiring service. [. . . ]