User manual CATEYE HL-MH310

[. . . ] · Do not use this light on public roads. The light output is equal to an automobile's halogen bulbs. Adjust the light accordingly so as not to blind oncoming traffic. · Stop using the light at once if the lamp unit, cord or bottle battery has broken. [. . . ] In addition to its high brightness, the beam is widely diffused. In case you should use this light on public roads, he sure to adjust the angle downward so as not to blind oncoming traffic. 2 Stadium Light Warning!!!Important Note E bracket (H-27) HOW TO MOUNT Mount the lamp unit to the bracket, the ballast to your frame and bottle battery to your bottle cage. Then connect the jack of the bottle battery with the plug of the ballast. Installing Bracket rubber pad bolt lamp body 1. Attach the bracket to the handlebar using the appropriate rubber pads. Before tightening the bolts securely, adjust the angle of the beam and the position of the lamp body. (See "How to Adjust the Angle of Beam" in the "Important Note". ) 3. (For a more secure fit, use a screwdriver. ) Mounting Lamp Unit slide bracket lever Warning !!!Never touch the lamp body until it is thoroughly cooled. · To mount the lamp body, slide it backward onto the bracket until it clicks into position. · To remove the lamp body, slide it forward while pushing the lever. Mounting Ballast bottle cage ballast Attach the ballast under the top tube and round the belt. If it is not secure, use the supporter and stopper as shown in the figure. If your frame is Y-frame, attach the ballast at the side of the frame. Note !: Be sure that the ballast is tightly attached to the frame. Installing Bottle Battery stopper bottle battery Insert the bottle battery into your bottle cage. Note !: The bottle battery might jump out of the bottle cage during ride. Be sure that it is tightly and firmly fixed. Connecting Cord supporter Connect the jack of the bottle battery's cord and the plug of the ballast's cord. Wind the cord round the frame so that it will not hinder riding. Note: Securely connect the jack to the plug. HOW TO USE The continuous run-time is 3 hours from the fully-charged condition. Note !: When the temperature is very high or low (even within the operating temperature range), the operation time might become shorter than the standard time due to the characteristics of the battery. · To switch on/off, press the yellow button on the ballast. When the light is on, the GREEN power-indicator turns on. · After switched on, it takes about 30 seconds for the light to reach its full brightness. [. . . ] For the information of the products, please also see CAT EYE website. LIMITED WARRANTY 2-Year Warranty: Only Lamp Unit, Ballast and AC Adapter (Excluding bulb and battery) If trouble or damage occurs during normal use, the product will be repaired or replaced free of charge. Type your name, address, date of purchase and the situation of trouble clearly, and send it back to the appropriate service center together with the product. Insurance, handling and transportation charges shall be borne by the customer. After being repaired or replaced, the product will be shipped back to the customer. [. . . ]