User manual CATEYE VECTRA WIRELESS

[. . . ] · Clean the computer and accessories with a soft cloth dampened with a neutral detergent. Do not use thinners, benzene, or alcohol on the computer. Troubleshooting No display. Replace it, and re-enter the correct information. (The speed is not displayed. ) [If the signal icon does not flash, reduce the distance between the sensor and computer, adjust the position of the magnet, and spin the wheel again. [. . . ] · Close to a railroad crossing, railway tracks, TV stations and or radar base. · Close to a second bicycle with wireless sensors. #169-6570 Bracket kit #169-9691 Wheel Magnet Replacing the Battery · Computer If the display appears faded or sensor reception is poor, replace the battery. The Total Distance can be entered manually. Before removing the battery, note the current Total Distance. Install a new lithium battery (CR2032) with the (+) side facing upward. Then re-start the computer according to the SETTING procedure, and then set the clock. c * When the batteries in either the main unit or sensor run down, please replace both the sensor and main unit batteries. · Sensor If sensor reception is poor, replace the battery. Then check the positions of the battery and magnet. #166-5150 Lithium Battery (CR2032) Correct installation of sensor and magnet A Attach the magnet 3 so that it passes through the sensor zone of the sensor 2. Option Parts #169-6667 Center Mount Kit B Be sure to have a 5 mm-or-less clearance between the sensor 2 and magnet 3. Part names A B C D Current Speed Sensor signal reception icon Flashes in sync with sensor signals. Speed unit Mode symbol . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . b Indicates the mode currently selected. [Clock] #169-9760 Magnet for Composite Wheel Specification Battery . . . . . . . . . . . Computer: Lithium Battery CR2032 X 1 Sensor: Lithium Battery CR2032 X 1 Battery Life . . . . 1 year (On the basis that the computer is used for 1 hour/ day) Sensor: until Total Distance reaches about 10, 000 km (6, 250 mile) * This is the average figure of being used under 20°C temperature and the dis tance between the computer and the sensor is 65 cm. Controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-bit 1-chip microcomputer (crystal controlled oscillator) Display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Liquid crystal display Sensor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No contact magnetic sensor Wheel Circumference Range 100 cm - 299 cm Working Temperature . . . . . . . . . . 0°C - 40°C (32°F - 104°F) Dimension/Weight . . . . . . . . . . . . . . . 40 x 55 x 21 mm [1-4/7" x 2-1/6" x 5/6"] / 30 g [1. 06 oz] * The factory-loaded battery life might be shorter than the abovementioned specification. * The specifications and design are subject to change without notice. E Battery Case Cover #169-9690 Hi-Power Wheel Magnet Starting/Stopping measurement This computer automatically starts measurement when the bicycle is moving. Switching Mode symbol . . . . . . . . . . . . . . . . . . . . . . [. . . ] Press the SET button again to set the clock, and revert to the measuring screen. * If the unit of speed is set to km/h, the 24-hour time system is activated. When set to mph, the 12-hour system applies. CO. , LTD. 2-8-25, Kuwazu, Higashi Sumiyoshiku, Osaka 546-0041 Japan Attn: CATEYE Customer Service Section Service & Research Address for USA CATEYE Service and Research Center 1705 14th St. [. . . ]