User manual CATEYE VELO 8

[. . . ] They must be disposed in accordance with local regulations. · Do not leave the main unit exposed to direct sunlight. · For cleaning of the main unit or accessories, use diluted neutral detergent on a soft cloth, and then wipe it off with a dry cloth. Do not use paint thinner, benzine or alcohol since such chemicals may damage the surface. [. . . ] Shift of Lower Display Each time you press the MODE button, a different data value appears on the lower line. e Power Saving Function If the main unit does not receive a signal after about 10 minutes, the main unit enters Power Saving Mode and displays the clock count only. To re turn to normal display, press the MODE button or start your bicycle again to cancel the Power Saving function. Data Reset When a screen with the Reset mark in the OPERATION FLOW is displayed, continue pressing the MODE button and the measured data will return to zero. However, the Odometer (total distance) and Clock do not return to zero. How to Set Clock In the clock mode, press SET button on the back, and the display enters clock setting mode. *If Km/h has been selected for speed scale, it becomes 24-hour clock. If mph has been selected, it becomes 12-hour clock. f How to Change Tire Size Display the Total Distance (Odo) and press the SET button to change the tire size. You can select a tire size in two ways: Either select from among preset sizes c or enter the tire's circumference directly in increments of 1 cm. d Maintenance · If the contact of the unit or the bracket gets wet, dry it off with a cloth. If they become rusty, it will cause speed detection error. · If the gaps between the buttons and the unit get clogged with mud or sand, wash them away with water. Has the battery in the main unit run down?Current speed does not appear. (First, short-circuit the contact of the main unit a few times with a piece of metal. If current speed appears, the main unit is working fine and the cause should be attributed to the bracket or the sensor. ) Is the clearance between the sensor and the magnet too large?Are the magnet's center and the sensor's marking line aligned?Re-adjust the positions of the magnet and the sensor. (The clearance should be less than 5mm. ) Is the cord broken?Even if the outside of the cord looks normal, there could be damage. [. . . ] It differs from the actual consumed calorie. 1 6 Click 7 km/h Speed Kcal per hour mph Speed Kcal per hour 10 km/h 67. 3 kcal 20 km/h 244. 5 kcal 30 km/h 641. 6 kcal 5 10 mph 155. 2 kcal 20 mph 768. 2 kcal 30 mph 2297. 2 kcal SETTING SETTING All Clear SET + MODE SET 2 buttons MODE #169-9550 Bracket Sensor Kit a Tm Dst Av Mx Cal Odo Clock Select km/h or mph Select km/h b PUSH! 0 Tire Size km/h MODE km/h SETTING END SET #166-5150 Lithium Battery (CR2032) #169-9691N mph Standard Magnet #169-9560 Wheel Size Tire size ETRTO 14 x 1. 50 14 x 1. 75 16 x 1. 50 16 x 1. 75 18 x 1. 50 18 x 1. 75 20 x 1. 75 20 x 1-3/8 22 x 1-3/8 22 x 1-1/2 24 x 1 24 x 3/4 Tubular 24 x 1-1/8 24 x 1-1/4 24 x 1. 75 24 x 2. 00 24 x 2. 125 26 x 7/8 26 x 1(59) 26 x 1(65) 26 x 1. 25 26 x 1-1/8 26 x 1-3/8 26 x 1-1/2 26 x 1. 40 26 x 1. 50 26 x 1. 75 26 x 1. 95 26 x 2. 00 26 x 2. 10 26 x 2. 125 26 x 2. 35 L (cm) 102 106 119 120 134 135 152 162 177 179 175 178 179 191 189 192 196 192 191 195 195 190 207 210 200 201 202 205 206 207 207 208 Tire size 57-559 26 x 3. 00 27 x 1 27 x 1-1/8 32-630 27 x 1-1/4 27 x 1-3/8 650 x 35A 650 x 38A 650 x 38B 18-622 700 x 18C 700 x 19C 20-622 700 x 20C 23-622 700 x 23C 25-622 700 x 25C 28-622 700 x 28C 700 x 30C 32-622 700 x 32C 700C Tubular 37-622 700 x 35C 700 x 38C 40-522 700 x 40C L (cm) 217 215 216 216 217 209 212 211 207 208 209 210 211 214 217 216 213 217 218 220 Heavy Duty Wire and Bracket Sensor Kit Tire Size 27" x 1-1/4 MODE 26 700c 27 [205] 16 18 20 22 24 47-305 Quick Setting Size START SETTING END SET MODE MODE c #169-9302 [#169-9307] Center Mount Bracket Kit [Long] 27" 47-406 #169-9303 Detailed Setting Size Bracket Sensor Kit for Aero Bar L = 216 (cm) cm d START #169-9304 Stem Mount Bracket Kit MODE MODE MODE 47-507 23-571 MODE 37-590 MODE (2 sec. ) #169-9690 Hi-Power Wheel Magnet (both for normal spoke & aero spoke) 40-559 47-559 50-559 54-559 57-559 MODE (2 sec. ) MODE MODE (2 sec. ) MODE SETTING END SET #169-9760 Magnet for Composit Wheel OPERATION FLOW Tm Reset e SET Data Reset Reset VELO 8 VELO 5 Tm Dst Av Mx Cal 0:00'00" - 9:59'59" Dst Reset 0. 00 - 999. 99 km [mile] SET MODE (2 sec) 0 f (00 - 59) MODE Av VELO8 Reset 0. 0 - 299. 9 km/h [0. 0 - 185. 0 mph] Clock Setting SET Mx MODE Reset VELO5 0. 0 (4. 0) - 299. 9 km/h [0. 0 (3. 0) - 185. 0 mph] MODE Setting Time MODE 3:10 (km/h 0 - 23) [mph 1 - 12] Cal*1 Reset 0. 0 - 9999. 9 kcal MODE Current Speed 0. 0 (4. 0) - 299. 9 km/h [0. 0 (3. 0) - 185. 0 mph] Odo 0. 0 - 9999. 9 km [mile] MODE MODE MODE Clock 0:00' - 23:59' [1:00' - 12:59'] SET SET SETTING END SET BATTERY Close CR2032 Open a All Clear g LIMITED WARRANTY 2-Year Warranty for Main Unit Only (Accessories/Attachments and Battery Consumption excluded) If trouble occurs during normal use, the part of the Main Unit will be repaired or replaced free of charge. The service must be performed by Cat Eye Co. , Ltd. To return the product, pack it carefully and remember to enclose the warranty certificate with instruction for repair. Please write or type your name and address clearly on the warranty certificate. [. . . ]