User manual CDA EVH9

[. . . ] Follow the local laws applicable for external air evacuation. Before connecting the model to the electricity network: - Control the data plate (positioned inside the appliance) to ascertain that the voltage and power correspond to the network and the socket is suitable. If in doubt ask a qualified electrician. - If the power supply cable is damaged, it must be replaced with another cable or a special assembly, which may be obtained direct from the manufacturer or from the Technical Assistance Centre. [. . . ] - Fix the lid once again by using the 4 screws previously removed in (Fig. 9A). · OPTIONAL ACCESSORIES This model may have decorative ducts as optional accessories - ask your retailer for information. Before fixing the decorative ducts, remove both the 4 screws B and lid M, as shown in (Fig. 10A-B). A sound-absorbing kit is also available (to be ordered as an OPTIONAL accessory) in order to increase the quietness level of the hood. The sound-absorbing layer must be applied to the back of the decorative panel. For fixing operations, refer to the instructions supplied with the kit. · INSTALLATION OF MODELS WITH DECORATIVE DuCTS Make sure the electrical power supply is within the measurements of the decorative connector. Adjust the width of the support bracket of the top connector (Fig. 11C). Then fix it to the ceiling so that it is on the same axis as the hood using screws A (Fig. 11C) adhering to the distance from the ceiling shown in (Fig. 11B). Connect flange C to the air exhaust hole using flexible hose L (Fig. 11D). Slide the top duct into the bottom duct. Fix the bottom duct to the hood using screws B (supplied) (Fig. 11E). Pull out the top duct as far as the bracket and fix it using screws F (Fig. 11C). · FILTER HOOD Please note: The filters should be ordered as accessories from your retailer. We offer 2 different types of kit which can be used to transform the EXTRACTOR hood into a FILTER hood, in accordance with the type of appliance model purchased. One kit contains extractable filters (fig. 10) and the other contains circular filters (fig. 1- If you find a bracket (such as the one indicated in fig. 14) included in the product packaging, this should be fixed to the hood using the 6 screws supplied. To replace the active carbon filters pull lever B outwards as shown in (Fig. 10). 2- If your product is not supplied with a bracket, this means that the active carbon filter is a circular version (fig. The filters should be fitted to the extraction assembly inside the hood, by centring them and rotating them 90 degrees, until they click into place (Fig. [. . . ] The Timer cannot be activated if the intensive speed is functioning. The "clean air" function is activated by pressing key E for 2 seconds when the appliance is switched off. This switches the motor on for 10 minutes every hour at the first speed. During functioning a rotary movement of the peripheral segments must be visualised on the display. [. . . ]