User manual CDA FWC600

[. . . ] · This appliance has been designed to work at an ambient temperature between 5º-38ºC. Use of the appliance outside of these parameters may cause the unit to fail. · This is a self-defrosting appliance. The compressor will not run during the thirty minute defrost cycle. Use and Controls FWC150 control panel 1 5 6 3 Key: 1 ­ Light button 2 ­ Set button 3 ­ Up/Down button 4 ­ Compressor indicator 5 ­ Alarm indicator 6 ­ Temperature display 2 4 FWC300/FWC600 control panel 1 2 5 4 6 3 For the FWC600 dual zone wine cooler the left control panel is for the upper zone, and the right control panel is for the lower zone. [. . . ] · Ensure that the cloth is only moist when cleaning the control panel and electrical parts, and that all water is thoroughly dried off before reconnecting the power. · Once cleaning is complete, then reconnect the mains electrical supply. · If the appliance is not to be used for prolonged periods of time, unplug and clean the appliance thoroughly. The door should be left slightly ajar to prevent the formation of odours or condensation. Troubleshooting If you have any problems with your appliance, you should check the troubleshooting guide prior to calling CDA Customer Care to prevent unnecessary service calls and potential cost. If the appliance is not working, check · There is power to the appliance · The house fuses are intact and the fuse in the plug has not blown. · The plug socket is functioning fine. To check this, plug another electrical appliance in to see if the socket is working. · The ambient temperature is between 5-38ºC. The appliance is working, but not very well, check · The appliance is not overloaded. · · · · · The thermostat is set to an appropriate temperature. The door gasket is sealing properly There is enough ventilation at the side and rear walls. The ambient temperature is between 5-38ºC. The appliance is noisy, check · · · The appliance is level and stable. The cooling gas will make a some noise, even when the compressor is not running. During operation, it is normal for the fan to run, even when the compressor is not running. The light does not work, check · · · There is power to the appliance The house fuses are intact and the fuse in the plug has not blown. The light button is not set to off Please note: The LED lighting cannot be replaced without a service call. If the light has failed, contact CDA Customer Care. The door will not close properly, check · The appliance is level and stable. · The door was reversed not correctly re-fitted · The door seal is dirty FWC150 Error code E FWC300 and FWC600 Error code Probe error - E. Description Sympton Advice Temperature sensor problem. Compressor cycles on for 5 minutes, and then off for 15 minutes continuously. Actual temperature inside the cabinet is lower than the temperature set. Actual temperature inside the cabinet is lower than the temperature set. Contact CDA Customer Care. L Low temp. Temperature too low. Contact CDA Customer Care. H High temp. Temperature too high. Check that the appliance door is closing fully. If the error code still persists, then contact CDA Customer Care. Installing the wine cooler This appliance is intended to be installed in a space between two units. [. . . ] To change a fuse in this type of plug, follow the steps below: 1. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse cover. Replace fuse cover. Important: Do not use the appliance without the fuse cover in position. How to connect an alternative plug If the fitted plug is not suitable for your socket outlet, then it should be cut off and disposed of safely to avoid possible shock hazard. A suitable alternative plug of at least 13 Amp rating to BS 1363 should be used. As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:· The wire which is coloured GREEN and YELLOW must be connected to the terminal which is marked with letter (E) or by the Earth symbol coloured BLACK. [. . . ]