User manual CDA RC9300

[. . . ] Gas cookers RC 9300 . . GB Users Operating Instructions Installation instructions Before operating this cooker, please read these instructions carefully Dear Customer Thank you for choosing one of our appliances, carefully designed and built by our specialist staff and thoroughly tested to satisfy your cooking requirements. We suggest that you read this Instruction Booklet so that you will understand fully how to operate your appliance. You may wish to refer to it at a later date. CDA Important: This appliance is designed and manufactured solely for the cooking of domestic (household) food and is not suitable for any non domestic application and therefore should not be used in a commercial environment. [. . . ] Remember to replace the floor correctly afterwards. Be careful not to confuse the tray "L" with the oven floor "F". L F Fig. 24 21 Removing the oven door Please operate as follows: · Open the door completely. · The swivel retainers of the rh and lh hinges (fig. 25a) are hooked onto the metal bar above them (fig. The noch on the bottom of the hinge will disengage (fig. · Now pull the oven door forwards off the appliance. Release both hinge sections from the slots (fig. 25b Door assembly · Grip the door (as indicated in figure 25) and refit it in reverse order of removing procedure. Fig. 25 22 FOR THE INSTALLER The appliance may be installed in a kitchen, Kitchen/diner or a bed sitting room, but not in a room or space containing a bath or a shower. The appliance must not be installed in a bed-sitting room of less than 20 m3. The appliance is designed and approved for domestic use only and should not be installed in a commercial, semi commercial or communal environment. Your product will not be guaranteed if installed in any of the above environments and could affect any third party or public liability insurances you may have. 23 Location This cooker has class "2/1" overheating protection so that it can be installed next to a cabinet. If the cooker is installed adjacent to furniture which is higher than the gas hob cooktop, a gap of at least 200 mm must be left between the side of the cooker and the furniture. The furniture walls adjacent to the cooker must be made of material resistant to heat. The veneered synthetic material and the glue used must be resistant to a temperature of 90°C in order to avoid ungluing or deformations. Curtains must not be fitted immediatly behind appliance or within 500 mm of the sides. It is essential that the cooker is positioned as stated below. The cooker must be installed by a qualified technician and in compliance with local safety standards. If the cooker is located on a pedestal it is necessary to provide safety measures to prevent falling out. 650 mm 450 mm 200 mm 500 mm air v 24 ent Fig. 26 Fitting the adjustable feet The adjustable feet must be fitted to the base of the cooker before use. Rest the rear of the cooker an a piece of the polystyrene packaging exposing the base for the fitting of the feet. [. . . ] Please help us to help you by having the following information available when booking a service-call: 1. Model type, make and model ­ see the product data plate. Evidence of installation / purchase date 3. Retailer where appliance was purchased 4. [. . . ]