User manual CDA TC15

[. . . ] This guarantee is valid providing that the mixer tap has been used for normal domestic purposes in the UK and that the care, installation and maintenance instructions have been observed. The warranty extends to the original purchaser only. You should retain a copy of your dated invoice as proof of purchase to validate any claims under this guarantee. Care Instructions for your Kitchen Sink Mixer: To maintain the appearance of this tap, ensure that it is regularly cleaned only using a clean, soft damp cloth. [. . . ] These installation guidelines have been prepared for your direction and you must exercise due care at all times. We do not accept responsibility for problems that may occur through improper installation. Whilst assembling the tap take care not to accidentally loosen any screwed assemblies. Installation Preparation: Before installing the new mixer it is essential that you thoroughly flush through the supply pipes in order to remove any remaining solder, swarf or impurities from your system. Failure to carry out this simple procedure could cause problems or damage to the workings of the mixertap. We strongly recommend installing particle filter strainers and isolation valves to both the hot and cold feed pipes in an accessible position. This will help to prevent premature failure of the valves and ease any future maintenance. All parts should be removed from their packaging and inspected for any transport damage prior to installation. Shut off your water heating system and ensure that your mains stopcock is closed. Open the lowest hot and cold taps in the house and allow the water to run until the cold-water storage tank and pipes are fully empty. Please note, the hot water storage cylinder (if applicable) will always remain full. This mixertap requires a 35mm tap hole, if replacing an existing tap, remove the tap & clean the end of the feed pipes using wire wool the tap hole area should be free from dirt and sealant. Loosely position the tap and tail pipes to check if any alteration to the existing pipework is required, if this is the case do this now. Installation: 1. Screw the studded rod (C) into the base of the tap (A). Screw the copper tail pipes (G&H) into the base of the tap, note the hot water should be connected to the left of the tap when viewed from the front. Pass the upper seal (B) over the studded rod (C) and tail pipes (G&H) and locate it centrally on the base of the mixertap (A). [. . . ] 9. Key A B C D E F G H I J K Description Mixertap body Upper sink/worktop seal Studded rod Rubber washer Metal horseshoe Fixing nut Hot rigid 15mm tail pipe Cold rigid 15mm tail pipe Compression Nut Compression Olive Non return valve Qty 1 1 1 1 1 1 1 1 1 1 1 After installation: Once you have visually checked the new fittings and connections, ensure that all taps are closed except the new mixer tap, which should be left open. Turn on the water supply at the mains stop cock. As the system starts to refill, check carefully for leaks. [. . . ]