User manual CEPAG STD32

[. . . ] We cannot accept any responsibility for consequential loss. We cannot be held responsible for material loss or personal injury that is due to incompetent use or non-compliance with the safety instructions. Therefore only touch the STD32 on the edges and avoid to touch the pins of components on the board. The one who makes the module operational by adding further components or putting it into a housing, is seen as manufacturer according to DIN VDE 0869 and obliged to hand out all necessary documents with the device and to indicate his name and address. [. . . ] The unit may only be repaired by a specialist. Only original parts have to be used when repairing the unit. The use of differing spare parts can cause serious material loss or personal injury. The device is designed for the remote switching of devices via the GSM network as well as the remote retrieval of status information of the inputs and the generation of SMS messages after status has changed at the inputs. A different use apart from the one described above is not allowed. The STD32 is a telemetry module which is easy to install and simple to use. With the STD32 you can control two relays and monitor the status of two digital inputs with a common mobile phone. Apart from the STD32 you only need a valid SIM Card of any network provider (GSM 900 / 1800 MHz). Typical fields of application are the opening of (garage) doors, switching on and off light and alarm devices as well as generating alarm messages (SMS) or the retrieval of information from door sensors, movement sensors or level sensors etc. As described in picture 1 the STD 32 has four pairs of screw terminals. Two pairs (In1, In2) are inputs to two optocouplers. The other two pairs (Relay1, Relay2) are outputs (switches) of the 2 relays of the STD32. When the engine is booked into the GSM network the GSM LED is flashing once every 2 seconds. In the following chapter "Startup" you will find further information on this. A) Preparation You need an activated SIM card of a GSM network provider. the PIN of this card has to be set to "0000". To change the PIN you can use a common mobile phone. The instructions how to change the PIN are described in the manual of your mobile phone. If you use a SIM card with a PIN different from "0000" in the STD32, the STD32 will use a "wrong" PIN after every restart. After the third trial your SIM card will be blocked. In this case you need to use the "Super-PIN" or "PUK" to assign a new PIN to your card. Please look into the user guide of your mobile phone. [. . . ] Take care that your mobile phone is transmitting the phone number (to check that you can call another mobile phone; your phone number or name must be visible on the display then) Now the relay should switch for a certain time according to the configuration. C) Send SMS Commands To protect your STD32 against unauthorized use every SMS has to start with the last 4 digits of the IMEI number. La destination de l'appareil est de permettre la mise en route et l'arrêt à distance d'appareils via le réseau GSM, ainsi que l'interrogation à distance des entrées et l'émission de SMS suite à une modification des entrées. toutre autre utilisation que celle expressément indiquée ci-dessus n'est pas autorisée. [. . . ]