User manual CHAMBERLAIN 750 INSTALLATION

[. . . ] Single-Button Remote Control Model 750 3-Button Remote Control Model 753 Figure 1 750 Series 753 Series 756 Series Push Buttons Mini 3-Button Remote Control Model 756 (­) (+) (0) (­) (+) (0) WARNING To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door: · ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control transmitters. [. . . ] NOTE: Code switch #1 on the Multi-function remote control is dormant when used with a single-function remote control. Set dip switch #1, in the single-function remote control, to match the push button selected on the Multi-function remote control (Figure 1). ­ 0 + ­ 0 + 1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9 AVERTISSEMENT ATTENTION + 0 ­ 1 2 3 4 5 Programming the opener RED-1 WHT-2 H I G H N ­ 0 + ­ 0 + Replacing the remote control battery WARNING To prevent possible SERIOUS INJURY or DEATH: · NEVER allow small children near batteries. · If battery is swallowed, immediately notify doctor. Locate the battery by either removing the case screw and the cover, or by sliding the battery compartment cover. Dispose of old batteries properly. CAUTION AVERTISSEMENT ATTENTION NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 1 2 3 4 5 6 7 8 9 6 7 8 9 ORM OR RED-1 WHT-2 H I G H N ORM If your unit has a "Learn" button: 1. Press and release the "learn" button located on the back panel of the motor unit. The learn indicator light will glow steadily for 30 seconds. [. . . ] Use a pen or screw driver to set the dip switches on the back of the remote control to match the dip switches on the back of the motor unit. Once the dip switches have been set push the remote control button to activate your unit. + 0 ­ 1 2 3 + 0 ­ H I G H N 4 5 6 7 8 9 OR AVERTISSEMENT 1 2 3 4 5 6 7 8 9 AVERTISSEMENT 114A1316E © 2006 The Chamberlain Group, Inc. [. . . ]