Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual CHAMBERLAIN 7710CB. We hope that this CHAMBERLAIN 7710CB user guide will be useful to you.
Lastmanuals help download the user guide CHAMBERLAIN 7710CB.
Detailed instructions for use are in the User's Guide.
[. . . ] The trolley must be in down (closed door) position during assembly and installation. If you have a completely installed garage door opener, the rail/opener assembly must be taken down. [. . . ] Disconnect the two master link assemblies from the trolley (Figure 2) and discard. Remove the 1/4"-20x1-3/4 bolt and lock nut from the trolley stop hole in the front rail and set aside. Push the trolley back toward the opener. Disconnect the front rail and second rail sections by using a screwdriver tip to pry up the outer tab on each side of the rail (Figure 3), then slide it off the existing rail assembly. Align the new front and center rails with the existing rail assembly, keeping the cut out "window" at the front (header) end. Be sure to keep rails right side up: the idler pulley bolt hole above the window is larger on top of the rail than on the bottom. Slide the new center rail onto the assembly, then add the front rail. Tabs along the side will lock into place. As a temporary trolley stop, clamp a locking pliers onto the rail, 8" (20cm) from the center of the idler pulley hole (Figure 4). Refer to your owner's manual to complete the assembly, re-installation and adjustment of your opener. NOTE: Before hanging the opener, an additional hanging bracket is necessary for stability. see Adding An Additional Hanging Bracket on reverse side. [. . . ] Concrete anchors MUST be used if installing any brackets into masonry. Hanging Bracket (Cross Brace) Not shown actual size [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE CHAMBERLAIN 7710CB
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual CHAMBERLAIN 7710CB will begin.
