User manual CHAMBERLAIN 845EML

[. . . ] Activate the opener only when door is in full view, free of obstruction and opener is properly adjusted. No one should enter or leave garage while door is in motion. [. . . ] Separate wires enough to connect the white/red wire to RED terminal screw 1 and the white wire to WHT terminal screw 2. Fasten the door control to an inside garage wall with sheet metal screws (3) provided. Drill 4mm (5/32") holes and use anchors (6) if installing into drywall. A convenient place is beside the service door and out of reach of children. Run the bell wire up the wall and across the ceiling to the garage door opener. use insulated staples (5) to secure wire. The receiver quick connect terminals are located behind the light lens of the opener. Connect the bell wire to the terminals as follows: white/red to red (1) and white to white (2). operation of the Door Control Press to open or close the door. Press again to stop the door while moving. Multi-function Door Control: Press the white square to open or close the door. Press again to stop the door while it is moving. Light Feature: Press the Light button to turn the opener light on or off. If you turn it on and then activate the opener, the light will remain on for 2-1/2 minutes. [. . . ] Skilj åt ledningarna tillräckligt för att kunna ansluta den vit-röda ledningen till RED-anslutningen (RED) (1) och den vita ledningen till WHT-anslutningen (2). Anslut signalledningen till följande kontakter: vit-röd till röd (1) och vit till vit (1). [. . . ]