User manual CHAMBERLAIN 942FP INSTALLATION

[. . . ] WARNING Overview ® Fingerprint Keyless Entry Model WARNING 942FP The system uses biometric technology that enables an authorized user to gain access by scanning their fingerprint. The sensor strip on the unit makes a numeric template of the fingerprint that is unique to that user. The unit's memory can store up to four fingerprints. · The term "enroll" refers to scanning the fingerprint so the device will recognize the user. [. . . ] Slide cover back into place. Battery Cover Screws SEND PASS READY ENROLL ENROLL FAIL RETRY 3 Replacement parts: Cover . . 41A6481 Troubleshooting · If no known enrolled users are available: -- The memory must be erased using the Factory Reset process. · If the unit does not recognize a swiped fingerprint: -- Ensure that the Ready LED is lit before you swipe. -- Ensure that fingerprint is swiped correctly (See Tips for Success). -- Ensure that sufficient pressure is being applied to sensor strip (do not press too hard). -- Ensure that the sensor and finger are not wet. · If the unit is in Enroll mode at power up: -- Complete enrollment process for initial user. -- The initial enroll process failed (signalled by a lit Enroll LED and Fail LED) and must be repeated. · If enrolling new user and all LEDs flash and unit returns to Ready mode: -- The memory is full. In order to add new user, the memory needs to be erased. · If the unit does not wake: -- A button may be stuck. Press Enroll and Resend buttons to ensure free movement. -- The batteries may need to be replaced. 114A3408 NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FOR SERVICE DIAL OUR TOLL FREE NUMBER: 1-800-528-9131 © 2007, The Chamberlain Group, Inc. All Rights Reserved ADVERTENCIA Generalidades La sistema usa tecnología biométrica que permite a un usuario autorizado tener acceso escaneando su huella digital. El sensor de la unidad forma una plantilla numérica de la huella digital que es exclusiva del usuario. Para saber si el abridor de puerta de cochera Chamberlain fue fabricado antes o después del 1 de abril de 1982, llamar al 1-800-528-9131 antes de instalar este control de radio universal. Paso 1 Instalar el receptor 1. Desenchufar el abridor antes de proceder. ARBIR EL RECEPTOR: Inserto un destornillador entre el abertura en el panal frontal de receptor como demostrar. Torcedura arriba el cubierta de actuador. [. . . ] Quite la tapa deslizándola completamente. Desenrosque los dos tornillos y quite la tapa de las pilas. ENROLL SEND PASS READY ENROLL FAIL RETRY Tapa PR · Para volver a poner la unidad en el estado de reajuste de fábrica: NOTA: El estado de reajuste de fábrica borrará TODAS las huellas dactilares almacenadas. Este método debe usarse SOLAMENTE cuando no se disponga de un usuario registrado, ya que requiere que el usuario reprograme el abridor. Abra la tapa y espere que se encienda el LED 1 Ready. Tapa de batería 3. [. . . ]