User manual CHAMBERLAIN 945CB

[. . . ] ® WARNING FOR USE WITH GARAGE DOOR OPENERS MANUFACTURED AFTER JANUARY 1, 1995. To ensure proper functioning of your opener, remove all old or previous push buttons/wall control panels. Use only the enclosed door control for proper operation. [. . . ] (Standard Installations ONLY) Run bell wire up wall and across ceiling to motor unit. Use insulated staples to secure wire to wall and ceiling in several places. Do NOT pierce wire with a staple, this will create a short or open circuit. Strip 7/16" (11 mm) of insulation from the end of the bell wire. Connect bell wire to terminals as follows: · Quick Connect Terminals: Red/white wire to red terminal and white wire to white (Figure 1). · Screw Terminals: Red/white to 1 and white to 2 (Figure 2). Reconnect power to the garage door opener. Replace the cover by inserting the bottom tabs and snapping it into place. Test the wall control to ensure proper operation. OPERATION Door Control Push Button: Press to open or close the door. Press again to reverse the door during the closing cycle, or to stop the door while it is opening. Light Feature: Press the Light button to switch the opener light on or off. When the door is opened or closed, the light will remain on for 4-1/2 minutes. Press the Light button to turn it off sooner. The Light button will not control the opener light when the door is in motion. Lock Feature: Designed to prevent operation of the door from portable remote controls. [. . . ] · Activate door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel. · ALWAYS keep garage door in sight until completely closed. NEVER permit anyone to cross path of closing garage door. Figure 1 Push Button Terminal Screws RED WHT Quick-Connect Terminals Bell Wire LOCK LIGHT Light Button Lock Button Door Control Connections Strip wire 7/16" (11 mm) 7/16" (11 mm) To release wire, push in tab with screwdriver tip Antenna Red White Grey OR Figure 2 Opener Terminal Screws Push Button Terminal Screws RED WHT Bell Wire LOCK LIGHT Lock Button Light Button Opener Panel Antenna 114A2381D © 2006, The Chamberlain Group, Inc. [. . . ]