User manual CHAMBERLAIN 963D

[. . . ] When moving a hand within close proximity to the remote control, the LED lights turn on for 3 seconds. Upon successful activation of a remote control button, the LED lights will blink rapidly. To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door: · ALWAYS keep remote controls out of reach of children. NEVER permit children to operate or play with remote control transmitters. · Activate gate or door ONLY when it can be seen clearly, is properly adjusted and there are no obstructions to door travel. [. . . ] The learn indicator light will glow steadily for 30 seconds. Within 30 seconds, press and hold the button on the hand-held remote. Release the button when the motor unit light blinks. If light bulbs are not installed, two clicks will be heard. NOTE: Feature only available on openers equipped with a multi-function control panel. Your 315MHz Security® remote control can be programmed to operate one door using all 3 buttons: the button with one light slot will only open the door, the button with two light slots will close the door, and the button with three light slots will stop the door's movement. You may set up this feature as follows: 1. With the door closed, press and hold the button with one 1 Light Slot light slot. Press and hold the Lock 2 Light Slots button on the multi-function (Close) control panel. Press and hold the main door control push button. When the opener lights flash, release all buttons. Test by pressing the 1 light slot button (Open) on the remote. Press it again while the door is open and nothing should happen. Press the 2 light slot button (Close) while the door is moving and it should close. Press the 3 light slot button (Stop) and the door should stop immediately. To Erase All Codes From Motor Unit Memory To deactivate any unwanted remote, first erase all codes: Press and hold the "learn" button on motor unit until the learn indicator light goes out (approximately 6 seconds). Reprogram each remote or keyless entry you wish to use. The Remote Control Batteries Troubleshooting PROBLEM SOLUTION Check if proximity lighting is disabled by pressing a button. Reduced proximity sensing (does not activate by touching top of remote control) The Proximity Sensor may be oversensitized. Sit remote control undisturbed for 60 seconds on a non-metallic surface. [. . . ] If bent, the proximity sensor will not work. Dim LED lights No rapid LED blinking after pressing a button Replace two 3V2016 batteries with same type 3V2016 coin cells. Replace two 3V2016 batteries with same type 3V2016 coin cells. Replacement Parts PART NO. 10A19 10A33 29C151 DESCRIPTION 3V2016 Lithium Battery: LED and Opener 3V2450 Lithium Battery: Proximity Switch Visor Clip QTY 2 1 1 FOR SERVICE, DIAL OUR TOLL FREE NUMBER: 1-800-528-9131 Proximity Battery LED and Opener Batteries Spring Contact NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. [. . . ]