User manual CHAMBERLAIN APT

[. . . ] Logic 3 OWNER'S MANUAL APT INDUSTRIAL DUT Y COMMERCIAL DOOR OPERATOR This Operator Features the Enhanced IN T ENA N C E M A E R T SYS T The Maintenance Alert SystemTM allows the installer to set an internal Maintenance Cycle Counter. The Logic 3 operator incorporates a self-diagnostic feature built into the (MAS) Maintenance Alert System LED. An LED on the 3-button station will signal when the set number of cycles/months is reached or when the operator requires immediate service. Radio Receiver Built on Board 2 YEAR WARRANTY 315MHz Serial # Box Installation Date NOT FOR RESIDENTIAL USE E PAT E N T P E N D I N G M A L TABLE OF CONTENTS SPECIFICATIONS Carton Inventory . . 4 PROGRAMMING Control Board Pushbuttons . [. . . ] Press and release the RADIO button on the logic board (LED flashes rapidly and then turns off). The programming mode is exited if no activity is performed within 30 seconds. ERASING REMOTES Press and hold the RADIO button on the logic board until the RADIO LED flashes rapidly (approximately 5 seconds). All remotes will be erased. SLS D26 CLS MRT MID D27 TIM RADIO 1 D36 2 RELAY C77 D35 C73 RELAY E2 D1 L1 LiftM ast er C2 C71 L5 B2 FAILSAFE P6 18 MOTOR REV C54 C78 ® PROGRAMMING Your 315MHz Security® or dip switch remote control can be programmed to operate as a 3-button wireless control station: the large button will open the door, the middle button will close the door, and the third button will stop the door's movement. You may set up this feature as follows: 1. To enter programming press the RADIO button on the logic board (the RADIO LED will light). To program the OPEN button to a remote control press the OPEN button on the logic board. The RADIO LED will flash and then stay on solid. Then press the corresponding button on the remote control. The RADIO LED on the logic board will flash, this confirms that the remote control has been programmed. (By programming the remote you use 1 channel of the 23 channels on the radio receiver. ) 3. To program the CLOSE button to a remote control press the CLOSE button on the logic board. The RADIO LED will flash and then stay on solid. Then press the corresponding button on the remote control. The RADIO LED on the logic board will flash, this confirms that the remote control has been programmed. (By programming the remote you use 1 channel of the 23 channels on the radio receiver. ) 4. To program the STOP button to a remote control press the STOP button on the logic board. The RADIO LED will flash and then stay on solid. Then press the corresponding button on the remote control. The RADIO LED on the logic board will flash, this confirms that the remote control has been programmed. (By programming the remote you use 1 channel of the 23 channels on the radio receiver. ) 5. After learning remote controls press the RADIO button on the logic board (LED will turn off). [. . . ] All errors self-correct when the corrective action is taken and a reset is not needed. 27 TROUBLESHOOTING RADIO FUNCTIONALITY The error codes will display at the radio LED. NOTE: Radio receiver is compatible with 315MHz remotes ERROR CODE R1 SYMPTOM No response from the remote DISPLAY Quick Flash POSSIBLE PROBLEM Unlearned remote A user tries to use a remote, but the RADIO LED only flashes briefly and there is no response from the operator. Cannot recognize remote A weak signal caused by a discharged battery or outside interference with the radio - OR - the radio being learned is not compatible with the operator. [. . . ]