User manual CHAMBERLAIN BARM6 BROCHURE

[. . . ] . 7-9 Assemble the Operator (Models T and GT) . 10 Attach the Track to the Header Bracket . 12 HOIST AND JACKSHAFT OPERATORS 13-17 Carton Inventory . 19 ENTRAPMENT PROTECTION 20-22 LiftMaster Monitored Entrapment Protection (LMEP) . [. . . ] The Timer-To-Close will function from the programmable mid stop with this wiring type. Compatible with 3-Button Station, 1-Button Station and 1 and 3-Button Remote Control. NOTE: A Programmable "Car Dealer Mode" available. T Momentary contact to open, close, and stop, with open override and Timer-To-Close. Every device that causes the door to open, except any safety edge input device, activates the Timer-To-Close. Auxiliary controls can be connected to open input to activate the Timer-To-Close. If the Timer-To-Close has been activated, the open button and radio control can recycle the timer. The stop button will deactivate the timer until the next command input. The Timer-To-Close will function from the programmable mid stop with this wiring type. Compatible with 3-Button Station, 1-Button Station and 1 and 3-Button Remote Control. NOTE: Programmable "Car Dealer Mode" available. · NEVER permit children to operate or play with door control push buttons or remote controls. Built in 3-channel, 315 MHz radio receiver allows you to add as many as 23 Security® remotes or dip switch remote controls NOTE: The following programming requires a LiftMaster Monitored Entrapment Protection (LMEP) device. To enter programming press and release the RADIO button on the logic board (RADIO LED will light). Press and hold the remote control button until the RADIO LED flashes rapidly, then release remote control button. The RADIO LED will then remain on solid after releasing the button. Repeat to add additional remote control(s). Press and release the RADIO button to complete the programming. The programming mode is exited if no activity is performed within 30 seconds. · Activate ONLY when it can be seen is properly CAUTION door there are no obstructions toclearly, travel. adjusted and door · ALWAYS keep door in sight until completely closed. NEVER permit anyone to cross the path of closing door. W W NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. [. . . ] 2-Button Control Station: OPEN CPS-EI CPS-EI E1 LMEP2 Monitored Safety Edge Interface: For use with the approved 4-wire safety edge (see below). OPEN CLOSE E2 E3 E4 40-34141-1 LMEP1 02-102 CLOSE 65ME1234 65ME110 Miller ME123 4-Wire Monitored Safety Edge: For sectional or rolling doors. OPEN Steel enclosure. Miller ME110 4-Wire Monitored Safety Edge: For rolling grilles and counter shutters. NON-MONITORED CLOSE 02-103L OPEN 3-Button Control Station: Steel enclosure with Maintenance Alert System. 65-8202 Key Control Station: CLOSE CLOSE STOP Vehicle Detection System: Pneumatic Sensing Edge Kit with exterior air switch, 2-wire coil cord and 14' air hose. 02-110 OPEN STOP Indoor flush mount, NEMA 1 with Stop button. 65-5202 Vehicle Detection System: Pneumatic Sensing Edge Kit with exterior air switch, 2-wire take-up reel (20' extended) and 14' air hose. MOUNTING BRACKETS 10-12360 Heavy gauge steel bracket for vertical or horizontal mount on either front or top of coil on a rolling door. [. . . ]