User manual CHAMBERLAIN CLSS1

[. . . ] Plugging Surge Protector into a GFCI (Ground Fault Circuit Interrupter) is acceptable, but not recommended as power surges may cause the GFCI to trip and you will need to reset the outlet in order to operate the garage door opener. Unplug Garage Door Opener from AC outlet and be sure power is disconnected BEFORE installing the Surge Protector. To protect the door opener low voltage control wires from lightning damage, control wires will be rerouted from the door opener to the surge protector, continuing the connection to the door opener. [. . . ] The terminals colored white and gray on the surge protector are designated for the IR sensor wires. Plug garage door opener into outlet on front of Surge Protector · test garage door opener for proper operation. Be sure to test all functions including wall control, keypad, safety sensors (Door Reversal Test - See garage door opener manual for instructions) and any other accessories. Note: After completing installation and restoring power to the garage door opener, check illumination of safety sensor LED's (located on safety sensors). If not illuminated, the wires for the safety sensors may be crossed at the Surge Protector. Verify that the safety sensor wires are connected to the gray and white terminals on the Surge Protector. If not, re-wire Surge Protector following above instructions. If connected to the gray and white terminals and LED's are still not illuminated, disconnect the twisted wires from both gray and white terminals and switch positions. Ensure they are making a good connection within the terminals of the Surge Protector. Reconnect AC power to both Surge Protector and garage door opener. LED Indicator: The indicator light should be illuminated when the surge protector is plugged into AC power and is protecting your garage door opener system. If the indicator light goes out, the surge protector has sacrificed (depleted) itself to protect the garage door opener system and should be replaced immediately. Chamberlain Connected Equipment Limited Warranty Chamberlain warrants to the original purchaser of any Chamberlain Surge Protector that the surge protector shall be free of defects in material and workmanship for a period of one (1) year from the date of original purchase, and will repair or replace, at its option, any defective surge protector free of charge. The proper operation of the Chamberlain Surge Protector may destroy the protector itself. [. . . ] All Chamberlain Surge Protectors must be plugged directly into the power source and must not be "daisychained" together in serial fashion with other power strips, UPS, other surge protectors or extension cords. any such installation voids the limited warranty. This limited warranty only protects against damage to properly connected equipment where Chamberlain has determined, in its sole discretion, that the damage resulted from an Occurrence, and does not protect against acts of God such as flood, earthquake, direct lightning strike, war, vandalism, theft, normal-use wear and tear, erosion, depletion, obsolescence, abuse, damage due to low voltage disturbances (i. [. . . ]