User manual CHAMBERLAIN CS7524

[. . . ] check shutter or sun-blind system regularly for signs of wear and damage. Damaged systems should not be used under any circumstances until such time as they have been repaired. observe shutter or sun-blind system carefully whilst in operation. Only those spare parts, tools and other equipment as have been approved by Chamberlain may be used. [. . . ] One button sends a signal for opening the shutter while the other closes it. If the button for the other direction is pressed when the shutter is in motion, the shutter stops. The switch can also be used to operate several drives providing they are within its range (same room). Automatic function: The user can program any set time required for UP or DOWN or for both. PROGRAMMING RADIO REMOTE CONTROLS (HAND-HELD TRANSMITTERS) Please note: In the following text, the radio-controlled wall switch is described as a remote control because the device concerned is a permanently mounted remote control (wall switch). up to 40x remote controls can be memorised. The first remote control programmed is also called the "master" remote control. PROGRAMMING A NEW, ADDITIONAL REMOTE CONTROL (not the first one or so-called master) PLEASE NOTE: The following steps must be executed quickly. The easiest way is for a second person to help by reading out the text while the other person presses the buttons. Step 1: The shutter should not be located at its limit. via the master remote control: Step 2: Press and hold the STOP button. The drive turns 2x briefly as a signal indicating that the command has been understood (approx. Step 3: Then press the UP button (upper button) and also the DOWN button (lower button) immediately and briefly. Once again the drive moves 2x briefly as a signal that the command has been understood. Via the new remote control: Step 4: Press and hold the UP button (upper button) on the new remote control immediately. Once again the drive moves 2x briefly as a signal that the command has been understood. 2 seconds are allowed as otherwise the process will be stopped. However, the drive must have halted beforehand. Note 3: Don't press a new button before the LED on the remote control has gone out and the drive has stopped moving. Should the drive run in one direction for a long time rather than a short time (between Step 2 and Step 3), the process hasn't worked. It also determines the direction of movement and decides whether the upper button is actually responsible for UP functionality or the opposite. Even if all that needs to be programmed is a reversal of direction of movement, all remote controls that have been programmed must still be deleted first (see Deleting with and without remote control). [. . . ] Example: If the shutter is closed by someone immediately after it has been opened, it would then be re-opened by the second transmission signal after 3 minutes. INSTALLATION: The radio-controlled wall switch is fitted to the wall in the same room as the drive it operates. Screws or adhesive tape should be used to fix it in place. TO OPEN: On the side is a marking identifying the point where a thin screwdriver can be applied to prise open the lid. [. . . ]