User manual CHAMBERLAIN CS8001

[. . . ] Non-compliance can result in serious injury. observe EN 60 335-2-97:2000 Safety Instructions in full. Any work on the electrical installation may only be performed by a qualified electrician. When electrical or electronic systems and appliances are in operation, certain components are live, which can constitute a risk. [. . . ] In this mode, pressure on the button causes the blind to move in the given direction for only a brief moment for light regulation purposes. The blind does not move to the limit switch unless the remote control button is pressed and held for longer than 2 seconds. Cable connections can no longer be used. Nevertheless, if there is a wall switch, a radio-controlled wall switch from the range of accessory products can be used instead (only for indoor purposes). Radio-controlled wall switch with automatic mechanism RA7524 · Shutter drive with separate control via cable for UP / DOWN (various models made by Chamberlain possible) If the jumper JP1 is removed completely, the connected drive will only run for as long as the button on the remote control is pressed and held. The controller can be removed from the cable side of the box. ⷠStep 1: On the side of the box where the cable is located are 2x small eyelets made of PVC near to the lid. Two small plastic pins have been inserted through the eyelets as security to ensure the box cannot open on its own. Step 2: Pull the parts apart with one hand holding the box and the other holding the cable. Therefore, retrofit receivers may only be installed in faultless shutter- or sun-blind systems. This guarantees safe operation and avoids damage during opening or closing. any other form of usage is deemed to be incorrect. Neither the manufacturer nor the supplier assumes any liability for personal injury, damage to property or consequential injury or damage occurring as a result of the use of the control units and / or drives for purposes other than those mentioned above or due to changes made to the equipment affecting the safety of the given system. the details stipulated in the Operating Instructions in respect of the operation and repair of the system require strict observance. Neither the manufacturer nor the supplier assumes any liability for personal injury, damage to property or consequential injury or damage occurring as a result of non-compliant actions. In compliance with standard EN 60 335-2-97:2000, the cable connecting the drives to the mains cable must be laid internally. According to DIN 18073 shuter box lid must always be easily accessible and removable. Carefully read all the information contained in this Owner's Manual before beginning installation procedures. [. . . ] PROGRAMMING a new remote control (radio-operated wall switch) Step 1: Connect power supply Step 2: Use a ball-point pen or similar to apply pressure lightly and briefly to the SEL button at the rear of the box. Then immediately press the UP button on the remote control and hold it until 1x peep is heard. Step 3: Then immediately press the DOWN button on the remote control and hold it until first 2x peeps and then 4x peeps are heard. Use a ball-point pen or similar to apply light pressure to and hold the SEL button at the rear of the box. [. . . ]