User manual CHAMBERLAIN FLA230

[. . . ] Turn off power to the operator BEFORE manually operating your door. 1b Bracket Shelf Mounting: The operator may be mounted either above or below the door shaft. NOTE: The optimum distance between the door shaft and operator drive shaft is between 12 - 15 inches. OPTIONAL Mounting Bracket P/N 08-9098 2 Place door sprocket on the door shaft. 3 Place drive sprocket on the appropriate side of the operator. Do not insert the key at this time. Electrical Interlock with Hoist To operate the hoist, pull the disconnect chain (small chain) to engage the hoist mechanism. [. . . ] Operate the door in the desired direction by pulling on one side or the other of the continuous loop hoist chain (large chain). The disconnect chain must be released from the chain keeper before the door will operate again electrically. 4 Wrap chain drive around door sprocket and join roller chain ends together with master link. 5 Raise operator to approximate mounting position and position chain over operator sprocket. Optimum Distance 12" - 15" Optimum Distance 12" - 15" 6 Raise or lower operator until the chain is taut (not tight). Make sure the operator output shaft is parallel to door shaft and sprockets are aligned. When in position, secure the operator to wall or mounting bracket. 7 Align sprockets, insert key into keyway, and secure. 8 Place hand chain around hand chain wheel. 9 Run the power wires through the power wiring conduit hole in the electrical box enclosure. Connect the earth ground to the ground screw in the electrical box enclosure. Follow ALL local electrical codes. Turn off power to the operator BEFORE manually operating your door. Electrical Interlock with Hoist 10 Adjust the limit switches to open and close door properly. Make sure the limit nuts are positioned between the limit switches before proceeding with adjustments. 11 Radio programming and troubleshooting instructions inside cover of operator. Inside the Electrical Box 9 Single Phase Connections HOT NEUTRAL EARTH 7 Align Sprockets Three Phase Connections 10 Limit Switches Retaining Plate SE L1 L2 Follow ALL national and local electrical codes. Press and release the STOP button to clear the timer. D21 2. Turn selector to PROG. OPEN D20 D13 5. Press and release the OPEN button once for every 1 second. Press and release the CLOSE button once for every 15 seconds. Example: Push CLOSE + Push OPEN + Push OPEN = 17 seconds total (15 seconds) (1 second) (1 second) 3. Press and release the MID button. CLOSE STOP D21 PROG MRT D13 MID TIMER OPEN D20 4. Press and release the MAS button. OPEN D20 8. Turn the selector dial back to the desired wiring type. T E2 D1 TS FSTS DIAG 6. Press and release the TIMER button to complete programming. MRT MID OPEN CLOSE STOP D20 4. Press the OPEN button, wait until the door reaches the desired mid stop height, then press and release the STOP button. [. . . ] Press the OPEN button, wait until the door reaches the desired mid stop height, then press and release the STOP button. Press and release the MID button to complete programming. MRT CLOSE STOP D21 TIMER C2 B2 OPTN PROG The OPEN LED will flash once for every 1 sec. The CLOSE LED will flash once for every 15 sec. T TS E2 D1 C2 B2 D13 D21 5. [. . . ]