User manual CHAMBERLAIN GWAP120

[. . . ] In order to avoid damage to the shutter installation during initial set up, the shutter strap must be wrapped around the strap spool at least twice when the shutter is open. 2mm Short time rating: max 5min Protection class II (only use in dry areas) Power cable H05 VV-F 2 x 0. Shutter size (shutter size = length x width): Plastic-Mini- Profiles approx. The shutter must open and close easily when used manually. [. . . ] The shutter strap coiler may only be used in connection with the provided wall plug transformer version 041AGW02. Installation of light sensor GWLS1 (accessory): A light sensor incl. 3m of power cable are separately available. In order to install the light sensor put the plug of the light sensor in the designated opening with the six pins at the bottom of the appliance (see fig. Clean the window pane and position the light sensor onto the window pane as desired. Information: The shutter strap motor will close the shutter after 15min of direct sunlight to the position of the light sensor. In order to open/close shutter again, press corresponding button on the control panel; this may also be achieved by activated timer control. To remove or relocate the light sensor only pull on the small plug (fig. Pulling/Pushing the white plastic top may lead to destruction of light sensor. Initial set up: Make sure that shutter can move freely. Make sure that stoppers/conical stops are existent and that these have a firm connection with the shutter. Now push any one of the three buttons of the shutter strap motor (fig. In the following the window size is automatically measured, i. The shutter strap motor will pull the shutter up until the conical stops reach the shutter box (or wall). A humming sound indicates the correct functioning of the motor. Then the shutter will be lowered automatically until completely closed and the lower limit is defined. Finally the shutter will be opened again automatically and will stop shortly before reaching upper limit. attention: The automatical measuring cannot be interrupted. Should this process be interrupted through power failure or should the plug be pulled accidentally, start over again = push any one of the three buttons. After completing this process the initial set up is finished. The shutter can be opened or closed by pushing the Open- or Close-button ( fig. Safety function: If obstacle is hit or shutter profiles are tilted the GWAP120 will shut down automatically. [. . . ] Upon receipt of the product, the first retail purchaser is under obligation to check the product for any visible defects. Conditions: The warranty is strictly limited to the reparation or replacement of the parts of this product which are found to be defective and does not cover the costs or risks of transportation of the defective parts or product. This warranty does not cover non-defect damage caused by unreasonable use (including use not in complete accordance with Chamberlain's instructions for installation, operation and care; failure to provide necessary maintenance and adjustment; or any adaptations of or alterations to the products), labor charges for dismantling or reinstalling of a repaired or replaced unit or replacement batteries. A product under warranty which is determined to be defective in materials and/or workmanship will be repaired or replaced (at Chamberlain's option) at no cost to the owner for the repair and/or replacement parts and/or product. [. . . ]