User manual CHAMBERLAIN GWUP180

[. . . ] Should you need to make use of your warranty entitlement, please submit the receipt together with the item concerned. In order to avoid damage to the shutter installation during initial set up, the shutter strap must be wrapped around the strap spool at least twice when the shutter is open. The motor replaces mechanical flush mount strap coilers with strap widths from 16mm up to max. The shutter must open and close easily when used manually. [. . . ] In order to open/close shutter again, press corresponding button on the control panel; this may also be achieved by activated timer control. To remove or relocate the light sensor only pull on the small plug (fig. Pulling/Pushing the white plastic top may lead to destruction of light sensor. The following spare parts are available: 041AGW45 strap spool for strap lengths up to 4. Direct connection to mains supply (optional): Attention: This work should be done by a skilled worker! the shutter strap motor may be connected directly to the mains supply. Open the cover at the back of the control panel using a tool, e. Loosen both screws of the connection clamp with a screw driver (fig. Now remove the screw of the strain relief and extract the cable. Now put the phase- and neutral-wire of the mains in both of the left clamps (random order) and reinsert both of the clamp screws. Put the cable back into the strain relief and tighten screw again using a screw driver (fig. Initial set up: Make sure that shutter can move freely. Make sure that stoppers/conical stops are existent and that these have a firm connection with the shutter. Now push any one of the three buttons of the shutter strap motor (fig. In the following the window size is automatically measured, i. The shutter strap motor will pull the shutter up until the conical stops reach the shutter box (or wall). A humming sound indicates the correct functioning of the motor. Then the shutter will be lowered automatically until completely closed and the lower limit is defined. Finally the shutter will be opened again automatically and will stop shortly before reaching upper limit. attention: The automatical measuring cannot be interrupted. Should this process be interrupted through power failure or should the plug be pulled accidentally, start over again = push any one of the three buttons. After completing this process the initial set up is finished. [. . . ] Upon receipt of the product, the first retail purchaser is under obligation to check the product for any visible defects. Conditions: The warranty is strictly limited to the reparation or replacement of the parts of this product which are found to be defective and does not cover the costs or risks of transportation of the defective parts or product. This warranty does not cover non-defect damage caused by unreasonable use (including use not in complete accordance with Chamberlain's instructions for installation, operation and care; failure to provide necessary maintenance and adjustment; or any adaptations of or alterations to the products), labor charges for dismantling or reinstalling of a repaired or replaced unit or replacement batteries. A product under warranty which is determined to be defective in materials and/or workmanship will be repaired or replaced (at Chamberlain's option) at no cost to the owner for the repair and/or replacement parts and/or product. [. . . ]