User manual CHAMBERLAIN HC600 INSTALLATION

[. . . ] This drive must not be used with a gate incorporating a wicket door. The actuating member of a biased-off switch, if installed, is to be located within direct sight of the gate but away from moving parts. Unless it is key operated, it is to be installed at a minimum height of 1, 5m and not accessible to the public. It is important to make sure that the gate always runs smoothly. [. . . ] The door leaf can move in an uncontrolled way, especially if it is defective and not properly balanced. The gate type (figure 2) determines the location where the drive mechanism is installed. If the gate stop is on the ground, the drive mechanism must also be installed at a height that is as low as possible so that it cannot twist the gate. Use only parts of the gate frame for fixing purposes. For steel gates, the gate fitting must be attached to the main frame. If you are uncertain whether the available support is sufficiently stable, reinforce it. In the case of wooden gates, the gate fitting must be through bolted. It is advisable to fit a plate from the outside so that the fixing brackets cannot become loose over time. Thin wooden gates must also be reinforced in order to withstand the stresses encountered. The release key should be inserted into the side openings and turned approx. 180 degrees until it cannot turn any further. To re-engage it, the key should be turned back to its original position (figure 11). The gate drive mechanism is suitable for use in conjunction with pillars with a max. The amount of room around the pier affects the opening angle and the position of the arms (figure 4). A different opening angle can be set for the left-hand wing as compared with the right-hand one (figure 3). Switch to manual operation by inserting and turning the hexagonal key provided (Fig. The side of the gate mounted to the pier should be stable. If necessary, it should be reinforced, e. Make sure that the screws used are long enough to ensure stable mounting. In the case of thick brick or concrete pillars, the hinge plate should be welded onto a support plate, that is mounted in such a way that the plugs cannot work loose. Adhesive shear connectors are better than steel or plastic wedge anchors for this purpose. A threaded rod is then mounted into the masonry with a stress free adhesive seal. [. . . ] Automatic Gate Opener, when installed and maintained according to all the Manufacturer's instructions in combination with a Gate, which has also been installed and maintained according to all the Manufacturer's instructions, meets the provisions of EU Directive 89/392/EEC and all amendments. I, the undersigned, hereby declare that the equipment specified above and any accessory listed in the manual conforms to the above Directives and Standards. The gate is opened by key or by entering a number. Contact strip (optional) Safeguards the gate on being touched. [. . . ]