User manual CHAMBERLAIN HC624ML

[. . . ] Automatic Gate Opener Models , when installed and maintained according to all the Manufacturer's instructions in combination with a Gate, which has also been installed and maintained according to all the Manufacturer's instructions, meets the provisions of EU Directive 98/38/EC and all amendments. I, the undersigned, hereby declare that the equipment specified above and any accessory listed in the manual conforms to the above Directives and Standards. This safety alert symbol means "Caution" - failure to comply with such an instruction involves risk of personal injury or damage to property. This gate drive mechanism is designed and tested to offer appropriately safe service provided it is installed and operated in strict accordance with the following safety rules. [. . . ] The control consists of several components which are fitted together and are screwed into the box. ) before turning your attention to this point. Find the following parts in the control box: - Remote control - Exterior installation box - Cover for box - Control - Transformer - Baseplate for transformer - Radio receiver - Radio module - Cable bushing large - Cable bushing small - Flat washer - Screws 3, 5x 9, 5 mm 1-2x* 1 1 1 1 1 1 1 1 1 5 17 Open the 4 pre-cut holes at the bottom of the casing with a screwdriver or a similar device. Attach large cable bushing on the left then the rest as shown in picture. humidity and water destroy the control. All openings and cable bushings must be sealed against water (waterproof). The control box with the motor control is to be mounted with the cable bushings facing down. Fasten control box of casing to wall, after previously measuring required distances and establishing correct position of drill-holes. On the right hand side of transformer there is sufficient space for a second transformer( Screws 3. Attach short earthing cable (yellow/green) to the plate using a screw and a washer. Attach logic board underneath baseplate; do this using 5 screws and fasten in the box at the marked positions. Before that pull all plug ins from their sockets. a small bag contains jumpers for the control. These might be needed later on individual settings in the controls' programming. (refer to JUMPERS) Put the 4 large closure screws of the box through cover of the box. Fasten 2 of them (left or right) approx 2cm into the box. After that the cover may be opened to the side. Close box on a trial basis turning the screws all the way in. If the lid does not close completely, then the box is not fitted to the wall evenly and is therefore distorted. It is very important for the box to be waterproof once closed. A) start with still dead 230Volts supply cable on the left side of the box. Then connect ground wire to base plate with washer and nut (exactly as shown in picture detail). [. . . ] If gate movement is impeded by weather or changes to the installation (rust or inappropriate lubrication) it may have to be repaired. The control board complies with the latest EU guidelines. One of these guidelines specifies that the closing forces at the gate edge must not exceed 400 N (40 kg) for the last 500 mm before the door is CLOSED. Above 500 mm, the maximum force at the gate edge must not exceed 1400 N (140 kg). [. . . ]