User manual CHAMBERLAIN ML700

[. . . ] Faites glisser le support de poulie libre (1) et le chariot intérieur (2) dans l'extrémité arrière (ouvre-porte) de l'ensemble du rail (3) ; veillez à insérer le support de poulie libre comme illustré. Montage au mur : centrez le support de boutisse (1) sur l'axe vertical (2) avec le bord inférieur du support de boutisse sur le trait horizontal (4) (avec la flèche vers le plafond). Si votre installation nécessite des trous de fixation supérieur et inférieur, utilisez le support de porte et la plaque de support de porte (2) comme illustré. Failure to comply with the following instructions may result in serious personal injury or property damage. [. . . ] Additional buttons on any rolling code 3-channel remote or mini-remote can be programmed to operate this or other rolling code garage door openers. Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should enter or leave garage while door is in motion. Do not allow children to operate push button(s) or remote(s). Do not allow children to play near the door. NOTE: Your new Keyless Entry must be programmed to operate your garage door opener. The learn indicator light will glow steadily for 30 seconds. Within 30 seconds, enter a four digit personal identification number (PIN) of your choice on the keypad (2), then press and hold the ENTER button. Release the button when the opener light blinks (3). If the light bulb is not installed, two clicks will be heard. NOTE: This method requires two people if the Keyless Entry is already mounted outside the garage. using the Multi-Function Door Control: 1. Enter a four digit personal identification number (PIN) of your choice on the keypad, then press and hold ENTER. Continue holding the ENTER and LIGHT buttons while you press the push bar on the Multi-Function Door Control (all three buttons are held). Release buttons when the opener light blinks. If the light bulb is not installed, two clicks will be heard. Travel limits regulate the points at which the door will stop when moving up or down. Follow the steps below to set the limits. Press and hold the black button (1) until the yellow indicator light (3) starts flashing slowly and then release. Push and hold the black button (1) until the door reaches the desired open position. Push the programmed remote control (4) or push bar on the door control that was shipped with your opener. The door will travel to the floor and reverse back to the UP (open) position. [. . . ] Do not use the manual release handle to pull the door opener or closed. If opening, the door will stop (allowing space for entry and exit of pets and for fresh air). If the door has been stopped in a partially open or closed position, it will reverse direction. The optional Protector SystemTM uses an invisible beam which, when broken by an obstruction, causes a closing door to open and prevents an open door from closing. [. . . ]