User manual CHAMBERLAIN NTD2

[. . . ] Volume: To increase the intercom volume, place Dipswitch #4 to the UP position. Sensitivity: To increase sensitivity on the intercom set Dipswitch #3 to the UP position. NOTE: Dipswitch #2 is not used. Carton Inventory Mounting Tape Mounting Intercom Alcohol Wipe Intercom (2) The Intercom can be mounted by using the included screws or by using the double-sided mounting tape. [. . . ] Firmly press mounting tape on back of intercom. Each intercom will emit a tone when entering programming mode. It may take up to 3-1/2 minutes for a secure network to be established. Step 3 Add to an Existing Network Peel paper from mounting tape. Firmly press intercom onto mounting surface. Press the Learn button on the new intercom until a beep is heard. Within 10 seconds put any networked intercom into Learn Mode (refer to table below). INTERCOM OR VOLUME MONITOR ACTIVE LEARN MODE Press the Learn button until a beep is heard. HOLD OFF Assemble Intercom TALK 1 2 3 4 CHANNEL Each intercom will emit a tone when entering programming mode. It may take up to 3-1/2 minutes for a secure network to be established. NOTE: Do not program new intercoms to each other before adding them to the network or they will form a separate network and the memory will need to be cleared. Install 4 AA Alkaline batteries (not provided). (Lithium batteries recommended for colder environments. ) 2 Secure Cover Troubleshooting Intercom does not function. When you press the Talk button you should hear a tone. Ensure Intercom is connected to a network. Intercom is not getting expected transmission range. Keep Intercom away from trees, metal objects and electrical wiring. Do not mount intercom on a tree, masonry, or metal surface. Secure cover with the two large black screws. Intercom beeps every ten minutes. Press and hold Learn button, an initial beep will be heard. Continue to hold until a second beep is heard (about 6 seconds). Ensure other intercoms are not activated during this time. Once memory is clear the intercom can be programmed to a new network. Intercom can not be programmed to network. [. . . ] · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. FOR TECHNICAL SUPPORT DIAL OUR TOLL FREE NUMBER: 1-800-528-9131 www. chamberlain-DIY. com NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. [. . . ]