User manual CHAMBERLAIN RA30

[. . . ] Any work on the electrical installation may only be performed by a qualified electrician. When electrical or electronic systems and appliances are in operation, certain components are live, which can constitute a risk. Any touching of and work performed on the equipment by persons not qualified to do so or non-compliance with safety instructions can result in personal injury or damage to property. all the standards and regulations applying to electrical installations must be observed. [. . . ] Carefully read all the information contained in this Owner's Manual before beginning installation procedures. Check the shutter to be sure it is not broken or damaged, and that it opens and closes smoothly. Determine whether the motor needs to be installed on the left side (a) or the right side, (b) of the shutter ­ Figure E . Install it on the side where the manual pull is located. Warranty for Tubular Motor Chamberlain GmbH warrants to the first retail purchaser of this product that the product shall be free from any defect in materials and/or workmanship for a period of 60 full months (5 years) from the date of purchase for RA10, RA20, RA30 or RA50 Series Models. Upon receipt of the product, the first retail purchaser is under obligation to check the product for any visible defects. Conditions: The warranty is strictly limited to the reparation or replacement of the parts of this product which are found to be defective and does not cover the costs or risks of transportation of the defective parts or products. This warranty does not cover non-defect damage caused by unreasonable use (including use not in complete accordance with Chamberlain's instructions for installation, operation and care; failure to provide necessary maintenance and adjustment; or any adaptations of or alterations to the products), labor charges for dismantling or reinstalling of a repaired or replaced unit or replacement batteries. A product under warranty which is determined to be defective in materials and/or workmanship will be repaired or replaced (at Chamberlain's option) at no cost to the owner for the repair and/or replacement parts and/or product. Defective parts will be repaired or replaced with new or factory rebuilt parts at Chamberlain's option. If, during the warranty period, the product appears as though it may be defective, contact your original place of purchase. This warranty does not affect the purchaser's statutory rights under applicable national legislation in force nor the purchaser's rights against the retailer arising from their sales purchase contract. In the absence of applicable national or EC legislation, this warranty will be the purchaser's sole and exclusive remedy, and neither Chamberlain GmbH nor its affilliates or distributors shall be liable for any incidental or consequential damages for any express or implied warranty relating to this product. No representative or person is authorized to assume for Chamberlain GmbH any other liability in connection wit the sale of this product. Rough- in or install conduit pipe to the connector box for the electrical connecting line according to local building and electrical codes. A Place the tube drive adapter (7) on the motor and fix the drive adapter with the parts (3 or 4). Fix the square pin with the screws on the motor (5 or 6). Procedure for Adjusting "Open" and "Close" Positions (refer to figure I for lefthanded installation) #1 Limit Setting for "Shutter Open" + = increase travel ­ = decrease travel Switch operates only if the drive unit is fully inserted. ensure that the adapter ring is pushed fully home. do not damage the tubular motor by drilling!E Proceed according to the specific requirements for leftsided (a) or right-sided (b) operation: F Secure the mounting bracket (8) to the wall (use suitable screws and plugs). g Insert the motor (a) into the mounting bracket (8) and secure it. [. . . ] Repeat this step as often as necessary to reach the desired position LIMIT ADJUSTMENT SCREW #2 - CLOSE Run the motor through a close cycle. O If motor stops too soon (before shutter is fully closed): Turn set screw #2 toward + and close shutter again, until desired position is reached. O If motor stops after shutter is fully closed: Retract shutter above desired position. Turn set screw #2 toward ­ and close shutter again. [. . . ]