User manual CHAMBERLAIN RWA300R

[. . . ] Replace with 9-Volt battery (not provided). For peak performance inspect batteries annually and replace as needed. Base Station Switches: Switch #1: OFF ON Buzzer Off Buzzer On (Default) OFF 1 2 ON Swivel Bushing Base Station Passive Infra-Red (PIR) Motion Sensor Rubber Pads Sun/Rain Shield Mounting Plate AC Adapter Switch #2: OFF ON Long Buzz Short Buzz (Default) Operation & Features Base Station Mute/Off Button Programming Additional PIR Motion Sensors: The Base Station can learn the code of up to 3 additional PIR Motion Sensors, responding with unique buzzes. To program additional PIR Motion Sensors see Step 6. [. . . ] Vehicle Alert Installation: For cars, the best mounting position is about 4' high, between 10-20' back, and angled to see the back of car after passing the sensor. Plug in Base Station. A 9-Volt battery (not provided) is optional in case of power failures. B 10' - 20' 3' - 5' Step 6 A A Ensure Base Station and PIR Motion Sensor are in close proximity to each other. Press and release learn button on Base Station. Buzzer will sound. Advanced Features COM (Common) N/O (Normally Open) - B ACCESSORY B Within 5 seconds, wave hand in front of PIR Motion Sensor. Test light will illuminate and Base Station will buzz. 3 The Base Station has a relay which can activate other devices such as a low voltage doorbell, buzzer or light. The accessory device will need a separate power supply. The accessories can be purchased at any electronics store. NOTE: Output switching capacity is low voltage (max 24V dc or ac). Troubleshooting The PIR Motion Sensor lights up, but the Base Station does not respond. The PIR Motion Sensor must be programmed to Base Station (See Step 6). Ensure Base Station is on and is not muted. If the green power light is not lit or is flashing, press the Mute Button on the top of the Base Station to wake it up. If the green power is illuminated, look at the two small white Base Station switches next to the Learn Button. The #1 Dip Switch should be down, towards the circuit board. If it is up, the Base Station has been muted. If the Base Station signals when you press the Learn Button, it is not muted. The Alert is not getting expected transmission range. Keep both antennas vertical and keep PIR Motion Sensor antenna away from trees and metal objects. Ensure Base Station is in clearest possible sight of the PIR Motion Sensor. The less objects between the devices, the longer the range. [. . . ] NOTE: Output switching capacity is low voltage (24V max, ac or dc). NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment. FOR TECHNICAL SUPPORT DIAL OUR TOLL FREE NUMBER: 1-800-528-9131 www. chamberlain-DIY. com NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. [. . . ]