User manual CHAMBERLAIN SL930

[. . . ] MODEL SL930 DC BB HEAVY DUTY COMMERCIAL SLIDE GATE OPERATOR MODEL SL930 2 YEAR WARRANTY Serial # ________________________ (located on electrical box cover) Installation Date__________________ MODEL SL930 IS FOR VEHICULAR PASSAGE GATES ONLY AND IS NOT INTENDED FOR PEDESTRIAN PASSAGE GATE USE TABLE OF CONTENTS OPERATOR SPECIFICATIONS Carton Inventory . . 5 IMPORTANT NOTES · BEFORE attempting to install, operate or maintain the operator, you MUST read and fully understand this manual and follow all safety instructions. · DO NOT attempt repair or service of your commercial door and gate operator unless you are an Authorized Service Technician. OPERATOR WARNINGS Safety Installation Information . . 6 Suggested Entrapment Protection Device Locations . [. . . ] Figure 2 Knockout Flexible Conduit Handy Box CIA N ADVERTENCIA ADVERTENCIA Ground Receptacle Neutral Hot Power Cord 13 WIRING BATTERY BACKUP If the operator is already factory equipped with a battery backup, only the Right/Left Side switch and Mode 1 are supported (Figure 3). The Right/Left switch simply needs to be set in the same position as the Right/Left switch on the main control board (see page 22). Gate will continue to operate when power is lost. Disconnect the brown and red wires from terminals 13 and 14 and insulate the ends of the wires. Attach 14 terminal charger board to terminal screws on the left side of control board and secure using terminal screws. Connect green wire from terminal 2 to terminal 15 of the control board. Connect orange wire from terminal D of the charger board to terminal 18 of the main control board. Connect red wire from terminal A to battery positive (+) and black wire from terminal B to battery negative (-) (Figure 4). Figure 3 (Set same as RIGHT/LEFT switch on control board. ) Figure 4 Disconnect these existing wires from 13 and 14. Existing Bridge Rectifier 14 WIRING CONTROL WIRING OPEN INPUT Any device that is used to open the gate from a closed position is an open input device. The device used must provide normally open contacts. These normally open contacts are connected to terminals 5 and 6. These open input terminals will cause the gate operator to open and/or close if the timer switch is in the OFF position. If the timer switch is in the ON position, these open input terminals will cause the gate operator to open and will hold the gate open until the input is released and the auto close time has elapsed. CLOSE INPUT Any device that is used to close the gate is a close input device. The device used must provide normally open contacts. These normally open contacts are connected to terminals 9 and 10. These close input terminals will cause the gate operator to close the gate any time the gate is in a non-closed position and can be used to override the timer and close the gate prematurely. STOP Figure 5 Push Buttons, Key Switches, etc. SAFETY OPEN PULSE OPEN Any device that is used to stop the gate operator while it is running in the open or closed direction is a stop input device. These stop input devices must provide normally closed contacts. To connect these normally closed contacts, remove the stop jumper from terminals 8 and 9 and then connect the contacts to these same terminals 8 and 9. STOP INPUT This input functions identical to N. C. [. . . ] This is done by turning the open and close gate sensitivity adjustments clockwise for more sensitivity (see page 22). Make sure that the Right/Left Side operation switch is in the correct position (see page 22). If the Right/Left Side operation switch is in the incorrect position, the auto close timer feature may be working in reverse and telling the gate operator to open after the auto close time has elapsed. Check to see if any input LEDs on terminals 4, 5 or 7 flicker or illuminate when the gate gets to the closed position. [. . . ]