User manual CHAMBERLAIN TCTRX2ED

[. . . ] For assembly purposes it is essential to ensure that the unit has no power connected to it. If the drive runs backwards please exchange the connecting lines to the motor at the terminals. Programming of the units and learning (teach-in procedure) should take place before final installation. During this procedure the units should be a maximum of 5 metres away from one another. [. . . ] In program mode "A1" the roller shutters open and close each day automatically at the programmed times. In program mode "A7" the roller shutters open and close automatically each weekday at individually programmed times. Automatic opening and closing of the roller shutters at different times (according to the day of the week) 8. For each weekday you can also enter different opening and closing times. Enter an opening time then confirm the hours and minutes with the UP key. Then enter a closing time and again confirm the hours and minutes with the UP key. Now select all the other weekdays and program the opening and closing times. Then select Return and then Return again. The roller shutters will now open and close on each day individually according to the programmed times. If instead of entering a time you enter a double hyphen (--) this will deactivate the opening or closing time. You can use this function to automatically close the roller shutters in the evenings so that you can then open them manually in the morning or vice versa. Under the menu option Events you can easily switch between the two automatic programs. Under the menu option Autom you can switch off the automatic functions completely. Here too the programmed times will remain stored in the memory. Combination with the radio wall switch TCTX2ED. The manual commands always take precedence over those programmed into the TCTRX2ED. the word Buttons appears briefly on the display. Select Return, then Mode and then Radio. In other words the TCTTX2ED can be used as a central switch which controls several roller shutters at the same time. 2 In the menu option Radio (under Mode) you can now select which radio signals are to be received. Select on to receive the signals from the wall switch and the optical sensor. Select Buttons if only the manual control commands from the TCTX2ED and the TCTTX2ED are to be received. [. . . ] This warranty does not cover non-defect damage caused by unreasonable use (including use not in complete accordance with Chamberlain's instructions for installation, operation and care; failure to provide necessary maintenance and adjustment; or any adaptations of or alterations to the products), labor charges for dismantling or reinstalling of a repaired or replaced unit or replacement batteries. A product under warranty which is determined to be defective in materials and/or workmanship will be repaired or replaced (at Chamberlain's option) at no cost to the owner for the repair and/or replacement parts and/or product. Defective parts will be repaired or replaced with new or factory rebuilt parts at Chamberlain's option. If, during the warranty period, the product appears as though it may be defective, contact your original place of purchase. [. . . ]