User manual CHAMBERLAIN TCTTX2ED

[. . . ] For assembly purposes it is essential to ensure that the unit has no power connected to it. If the drive runs backwards please exchange the connecting lines to the motor at the terminals. Programming of the units and learning (teach-in procedure) should take place before final installation. During this procedure the units should be a maximum of 5 metres away from one another. [. . . ] The roller shutters will now open and close each day at the programmed times. In program mode "A1" the roller shutters open and close each day automatically at the programmed times. In program mode "A7" the roller shutters open and close automatically each week day at individually programmed times. Automatic opening and closing the roller shutters at different times (according to the day of the week) 8. For each weekday you can also enter a different opening and closing time. Enter an opening time then confirm the hours and minutes with the UP key. Then enter a closing time and again confirm the hours and minutes with the UP key. Now select all the other weekdays and program the opening and closing times. The roller shutters will now open and close on each day individually according to the programmed times. If instead of entering a time you enter a double hyphen (--) this will deactivate the opening or closing time. You can use this function to automatically close the roller shutters in the evenings so that you can then open them manually in the morning or vice versa. Under the menu option Events you can easily switch between the two automatic programs. Under the menu option Autom you can switch off the automatic functions completely. Here too the programmed times will remain stored in the memory. Remote control of roller shutters which are equipped with the radio wall switch TCTX2ED and the receiving module TCRX3ED. The TCTTX2ED can remotely control other roller shutters if they are fitted with a TCRX3ED and a TCTX2ED unit. The data from the automatically time-controlled opening and closing process can be transmitted as well as the manual control commands. With a special pointed implement press the learning key on the back panel of the TCTX2ED. (If these roller shutters are controlled by several TCTX2EDs, press the learning key on the TCTX2ED master transmitter). In the TCRX3ED you will now hear a rhythmic acoustic signal. Select Return, then Mode and then Radio. In this menu you can now decide which control signals will be sent. [. . . ] This warranty does not cover non-defect damage caused by unreasonable use (including use not in complete accordance with Chamberlain's instructions for installation, operation and care; failure to provide necessary maintenance and adjustment; or any adaptations of or alterations to the products), labor charges for dismantling or reinstalling of a repaired or replaced unit or replacement batteries. A product under warranty which is determined to be defective in materials and/or workmanship will be repaired or replaced (at Chamberlain's option) at no cost to the owner for the repair and/or replacement parts and/or product. Defective parts will be repaired or replaced with new or factory rebuilt parts at Chamberlain's option. If, during the warranty period, the product appears as though it may be defective, contact your original place of purchase. [. . . ]