User manual CHAMBERLAIN WD962KLD

[. . . ] 845 Larch Avenue Elmhurst, Illinois 60126-1196 www. chamberlain. com ® GARAGE DOOR OPENER Models WD962KD WD962KLD For Residential Use Only Owner's Manual Please read this manual and the enclosed safety materials carefully!Fasten the manual near the garage door after installation. The door WILL NOT CLOSE unless The Protector System® is connected and properly aligned. Periodic checks of the opener are required to ensure safe operation. [. . . ] · Center the door bracket on the top of the door, in line with the header bracket as shown. Mark either the left and right, or the top and bottom holes. · Metal Doors: Drill 3/16" pilot holes and fasten the bracket with the 1/4"-14x5/8" self-threading screws provided. · Wood Doors: Drill 5/16" holes and use 5/16"x2" carriage bolts, lock washers and nuts (not provided) or 5/16"x1-1/2" lag screws (not provided) depending on your installation needs. NOTE: The door bracket may be installed on the top edge of the door if required for your installation. (Refer to the dotted line optional placement drawing. ) HARDWARE SHOWN ACTUAL SIZE Self-Threading Screw 1/4"-14x5/8" Self-Threading Screw 1/4"-14x5/8" Header Wall 2x4 Support Finished Ceiling Door Bracket Top of Door (Inside Garage) Top Edge of Door Header Bracket Optional Placement Door Bracket METAL DOOR Optional Placement of Door Bracket HORIZONTAL AND VERTICAL REINFORCEMENT IS NEEDED FOR LIGHTWEIGHT GARAGE DOORS (FIBERGLASS, ALUMINUM, STEEL, DOORS WITH GLASS PANEL, ETC. ). (NOT PROVIDED) Nut 5/16"-18 Lock Washer 5/16" Top of Door (Inside Garage) Top Edge of Door Optional Placement Carriage Bolt 5/16"x2" (Not Provided) Vertical Centerline of Garage Door Door Bracket For a door with no exposed framing, or for the optional installation, use lag screws 5/16"x1-1/2" (Not Provided) to fasten door bracket. WOOD DOOR 25 INSTALLATION STEP 13 Connect Door Arm to Trolley Follow instructions which apply to your door type as illustrated below and on the following page. SECTIONAL DOORS ONLY Make sure garage door is fully closed. Pull the emergency release handle to disconnect the outer trolley from the inner trolley. Slide the outer trolley back (away from the pulley) about 8" (20 cm) (Figures 1, 2 and 3). Figure 1: · Fasten straight door arm section to outer trolley with the 5/16"x1" clevis pin. Secure the connection with a ring fastener. · Fasten curved section to the door bracket in the same way, using the 5/16"x1-1/4" clevis pin. Figure 2: · Bring arm sections together. Find two pairs of holes that line up and join sections. Select holes as far apart as possible to increase door arm rigidity. Figure 3, Hole alignment alternative: · If holes in curved arm are above holes in straight arm, disconnect straight arm. Cut about 6" (15 cm) from the solid end. Reconnect to trolley with cut end down as shown. · Find two pairs of holes that line up and join with bolts, lock washers and nuts. Pull the emergency release handle toward the opener at a 45° angle so that the trolley release arm is horizontal. Trolley will re-engage automatically when opener is operated. Pulley 8" (20 cm) min. Trolley Stop Bolt Ring Fastener Inner Trolley Outer Trolley Clevis Pin 5/16"x1" Door Bracket Emergency Release Handle Straight Door Arm Clevis Pin 5/16"x1-1/4" Curved Door Arm Figure 1 Pulley 8" (20 cm) min. Trolley Stop Bolt Lock Washers 5/16" Nuts 5/16"-18 Bolts 5/16"-18x7/8" Door Bracket Figure 2 Pulley 8" (20 cm) min. HARDWARE SHOWN ACTUAL SIZE Trolley Stop Bolt Lock Washers Nuts 5/16" 5/16"-18 Nut 5/16"-18 Lock Washer 5/16" Ring Fastener Clevis Pin 5/16"x1" (Trolley) Clevis Pin 5/16"x1-1/4" (Door Bracket) Hex Bolt 5/16"-18x7/8" Bolts 5/16"-18x7/8" Cut this end Figure 3 26 ALL ONE-PIECE DOORS 1. [. . . ] SIMPLY DIAL OUR TOLL FREE NUMBER: HOW TO ORDER REPAIR PARTS Selling prices will be furnished on request, or parts will be shipped at prevailing prices and you will be billed accordingly. WHEN ORDERING REPAIR PARTS, ALWAYS GIVE THE FOLLOWING INFORMATION: · PART NUMBER · PART NAME · MODEL NUMBER ADDRESS ORDERS TO: THE CHAMBERLAIN GROUP, INC. Country Club Road Tucson, Arizona 85706 SERVICE INFORMATION TOLL FREE NUMBER: 1-800-528-9131 www. chamberlain-diy. com For professional installation, parts and service, contact your local CHAMBERLAIN® dealer. Look for him in the Yellow Pages, or call our Service number for a list of dealers in your area. 1-800-528-9131 CHAMBERLAIN® ONE-YEAR LIMITED WARRANTY 10 YEAR BELT LIMITED WARRANTY & LIFETIME MOTOR LIMITED WARRANTY The Chamberlain Group, Inc. [. . . ]