User manual CHANEY INSTRUMENT MODEL 00736 WIRELESS WEATHER FORECASTING STATION AND REMOTE SENSOR

[. . . ] If additional sensors are purchased the main unit will automatically assign these sensors to open channels. Sensor unit: The sensor can transmit up to 100 feet without outside interference (e. g. metal surfaces, electrical devices, etc). detachable probe can be submerged to measure the temperature in ponds, aquariums, etc. [. . . ] On the main unit, select between Celsius and Fahrenheit temperature readings by pressing the + C/F button. To add an additional sensor make sure batteries are in the main unit first, then place batteries in the additional sensor and press the reset or Tx button. The main unit automatically searches for an open channel to register the signal for the new sensor. The weather forecaster will automatically read the atmospheric pressure and predict the weather conditions for the next 12 hours; this is based on calculations only and may not be representative of conditions. After initial set-up, the unit may need 12-24 hours to read atmospheric pressure. Pressure Trend Indicator: Pressure trend icons indicate steady, falling, or rising pressure. The pressure trend indicator will refresh every hour. The arrow shown indicates: Steady Falling Rising 2. 3. 4. Storm Alert: The cloud and rain icon will flash when the sensor unit detects stormy conditions. Day/Night Icon: The sun (indicating daytime) will change to the moon and stars (indicating nighttime) after 9:10 pm (21:10). The nighttime indicator will remain until 5:10 am (05:10), at which time the daytime indicator returns. MIN/MAX/MEMORY: The main unit automatically stores the high and low temperature. Pressing the max/min button will display the maximum temperature for 5 seconds. Press the button again to display the minimum temperature for 5 seconds. To clear the stored temperature, press the clear button while the value you wish to clear (max or min) is displayed. TROUBLESHOOTING: At times, the main unit may display "---" in the remote temperature if outside interference is occurring. Most of the time the unit will re-sync the signal on it's own. However, if this should continue to occur, the following may also be the reason: A. The sensor has been placed outside of the effective transmission range (more than 100 feet). Move the sensor closer to the main unit. Sensor units may have outside interference that is preventing proper transmission. Sources of interference include but are not limited to metal surfaces, electrical devices, etc. The sensor may need to be relocated if interference continues. TEMPERATURE ALERT: Minimum and maximum temperature alerts can be programmed. To turn the feature on or off, press the alert button. When the icon is displayed this feature is on. [. . . ] A bell icon will appear in the time panel to show that the alarm is set. To view the time the alarm is set for, press the clear button. The alarm time will display for 5 seconds and then switch back to normal clock mode. When alarm goes off, the alarm will sound for 1 minute. [. . . ]