User manual CHANEY INSTRUMENT MODEL 00786 WIRELESS THERMOMETER WITH HUMIDITY

[. . . ] Additional sensors may be purchased seperately. Set channel 2 if using a second sensor, or channel 3 if using a third sensor. To purchase additional sensors call 1-800-KLOCKIT and ask for wireless remote sensor model 00911. [. . . ] If the home receiver location you selected does not work, change to a location in another part of the room or building. Radio Controlled Time Reception Set Up: The clock attempts to synchronize with the Atomic time signal AUTOMATICALLY right after the first sensor is registered. The unit will start synchronizing the clock after registering the remote sensor thermometer reading. An antenna icon appears in the upper right hand of the time section. The clock will not respond to any manual settings while attempting to receive the Radio Control Time Signal. This reception cycle lasts from 2 to 5 minutes. The antenna icon remains fixed after the clock is synchronized. Entering The Time Zone: After the unit successfully synchronizes withthe atomic time signal, the time zone must be entered. · Press & hold "C/F ZONE" button on the back of the home reciever for 3 seconds, press "C/F ZONE" button to select P/M/C/E time zones. The letters appear in the area where the seconds are shown in the time display. When you select thecorrect time zone, press the "SET" button to confirm your choice and exit the selection mode. P = P acific Standard Time M = Mountain Standard Time C = Central Standard Time E = Eastern Standard Time 1 STEP THREE: MANUALLY SETTING THE CLOCK & CALENDAR Press and hold the "SET" button for 3 seconds: · The setting sequence is: Year > Month > Date > Hr > Min > 12/24 hr > DST on/off > Weather Offset > EXIT Settings · Press the "+" or "-" buttons on the back of the Receiver to set each function to the correct setting. Once the display is showing the correct setting, press the "SET" button to confirm your settings and to advance to the next function. · The corresponding digits will be flashing during the setting procedure. · After completing the setting sequences pressing the "SET" button will return the display to the standard view. ADDITIONAL FEATURES Setting the Alarm: Press and hold the "ALARM" button for 3 seconds. · The display will show the alarm set time and the letters "AL" appear to the right of the minute digits. · Press the "+" or "-" buttons on the back of the case to set the hours to your desired time. Please be sure to note that the AM/PM idicator is set properly. [. . . ] The min/max memory will automatically clear every day at midnight. Temperature Trend: Small arrow icons displayed in boxes will indicate: Rising, Steady, Falling. Refresh rate for the outdoor temperature trend is once every hour. [. . . ]