User manual CHANEY INSTRUMENT NEWER MODEL 00754 WIRELESS WEATHER STATION AND ATOMIC CLOCK WITH REMOTE SENSOR

[. . . ] Please read the instructions thoroughly before setting up your wireless thermometer. The remote sensor is designed to stand or hang. For wall mounting, use the enclosed screw to mount to the desired surface. Use the slot on the back of the case to mount the remote sensor to the surface. 4 1 Quick Setup Guide: 1. [. . . ] NOTE: The main unit will reject any manual settings when it is automatically searching for the temperature and time settings. Setting up additional sensors: (Additional sensors can be purchased separately, Acu-rite model #00955) To add an additional sensor, make sure the batteries are in the main unit first, then place batteries in the additional sensor and press the "TX" button on the back of the sensor. The main unit will automatically search for an open channel to register the signal on the main unit. The main unit will accept up to 3 remote sensors. Auto Scroll: If additional sensors are used, the auto scroll feature will display each channel's temperature for 5 seconds. To activate the auto scroll feature, press the "channel" button until the arrow icon appears on the temperature screen. Additional Remote Sensor Placement Suggestions: Additional sensors can be purchased separately, Acu-rite model #00955 About The Wireless Thermometer Min/Max Temperature Memory: Press the "MIN/MAX" button to view the maximum values for 5 seconds, press again to view minimum memory values. When the "MIN/MAX" button is pressed, the time that the minimum and maximum temperatures were recorded within a 24-hour time period will display. The memory automatically clears every night at midnight. Temperature Trend Indicator: The 3 arrow icons will indicate Rising, Steady, or Falling if the temperature change is more than 1 degree an hour. A snowflake icon will appear on the main display if the temperature reaches 32ºF / 0ºC or below. The Trend icons will appear to the right of the remote sensor temperature readout on the main display. Battery Replacement: A low battery icon will appear when the main unit or the sensor needs new batteries. For the main unit, the icon will appear next to the indoor temperature readout on the main display. For the remote sensor unit, the icon will appear next to the remote temperature readout on the main display. NOTE: When replacing batteries in the main unit, the batteries in all remote sensors must be removed and re-installed according to the initial set-up process. When replacing the batteries in the remote sensor only, the channel on the main unit must be cleared. This can be achieved by selecting the appropriate channel and pressing the "CHANNEL" button for 3-5 seconds. Place new batteries in the remote sensor and then follow the quick setup guide above. · Outside your home or place of business · Wine cellars · In the garage · Childrens room · Gardens or greenhouses · Any location that remote temperature readings are beneficial About The Atomic Clock The main unit has a special receiving device that picks up an AM radio signal broadcasted by the National Institute of Standards and Technology (NIST) in Fort Collins, Colorado. The signal is generated from the official U. S. atomic clock that is the most accurate timekeeping device in the world!The AM radio signal transmits the exact hour, minute and second of the day. [. . . ] ( Continued on page 4 ) TROUBLESHOOTING: The main unit may display "---" if the signal is being interrupted by outside interference. In most cases, the unit will re-sync with the remote sensor on it's own. It may also help to bring the remote sensor closer to the main unit to re-sync the main unit and the remote sensor. However, should this condition continue to occur, be sure to check the following: A. [. . . ]