User manual CHARTER OAK S600

[. . . ] Keep this Quick Setup Guide and the supplied CD-ROM in a convenient place for quick and easy reference at all times. All other brand and product names mentioned in this user's guide are registered trademarks or trademarks of respective companies. 3 or greater If the CD supplied with your Brother Printer/MFC/DCP does not include a Windows NT® 4. 0 driver, you are not able to use it in Windows NT® 4. [. . . ] Step 5 Specifying the Scan Destination Address from the NC-2200w Home page You need to specify the scan destination address from the NC-2200w URL to use the scanner on a network. ) 3 Enter the IP address of your computer. – If the IP address of your computer was assigned automatically by DHCP, you should enter the computer name because the IP address may change. The name can be the Windows® computer name or the DNS host name. – To learn your computer name, open Properties from My Computer and refer to the Computer Name tab. To use the domain name you have to assign the DNS server address using the Web server of the NC-2200w and your Web Browser. 1 Open the Internet Explorer and enter the following in the URL field. Http://NC-2200w_ip_address Where NC-2200w_ip_address is the IP address or node name of your NC-2200w. – The IP address or node name of your NC-2200w is on the Network Configuration Page. For more information, see Other Information on page 16. Step 4 Installing and Configuring the Printer Driver using the Simple Network Configuration Capabilities of Mac OS® X You need to install the printer driver before setting up your computer to work with the NC-2200w. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ■ ■ ■ ■ Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. important Changes or modifications not expressly approved by Brother Industries , Ltd. [. . . ] Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. important Changes or modifications not expressly approved by Brother Industries , Ltd. Could void the user's authority to operate the equipment. [. . . ]