User manual CHERUB METRO TUNER WMT-555C

[. . . ] 40 mm Positioning  Keep all packaging materials out of the reach of children. it may present a choking or suffocation hazard (see Precautions and tips).  The appliance must be installed by a qualified professional in accordance with the instructions provided. Incorrect installation may damage property or cause harm to people or animals. [. . . ]  A few seconds after the hob is connected to the Switching off the cooking zones • Press the button: the power of the cooking zone will progressively decrease until it is switched off. And buttons may be • Alternatively, the pressed simultaneously. This immediately returns the power setting to 0 and the cooking zone switches off. gB electricity supply , a buzzer will sound. Switching on the hob To switch the hob on, press and hold the for approximately one second. Button Programming the cooking time  All the cooking zones may be programmed for a length of time between 1 and 99 minutes. Select the cooking zone using the corresponding selector button. Set the cooking time using the “-” and “+” buttons. Confirm by pressing the The timer begins counting down immediately. A buzzer sounds for approximately 1 minute and the cooking zone switches off when the set programme has finished. Repeat the above procedure for each hotplate you wish to programme. The hotplate only emits heat when a pan with suitable measurements for the cooking zone is placed on it. If the indicator light is flashing, it may indicate: • An incompatible pan • A pan whose diameter is too small • The pan has been removed from the hotplate. Residual heat indicators While the temperature of the cooking zone remains above 60°C, even after the programme has finished, the residual heat indicators placed near the relevant cooking zone remain lit to prevent the risk of burns. Overheating protection If the electronic elements overheat, the hob switches off automatically and “—” appears on the display. When the temperature has reached an appropriate level, this message disappears and the hob may be used again. Safety switch The appliance has a safety switch that automatically switches off the cooking zones when they have been in operation for a certain amount of time at a given power level. When the safety switch has been triggered, the display shows “0”. For example: the right rear hotplate is set to 5 and will switch off after 3 hours of continuous operation, while the front left hotplate is set to 2 and will switch off after 10 hours. Power level 1-2 3 4 5-6 7-8 9 * Cast iron Enamelled steel Special stainless steel Copper, Aluminium, Glass, Earthenware, Ceramic, non magnetic Stainless steel In addition, to obtain the best results from your hob: • Use pans with a thick, flat base to fully utilise the cooking zone. • Always use pans with a diameter that is large enough to cover the hotplate fully, in order to use all the available heat. • Make sure that the base of the cookware is always dry and clean, to fully utilise and extend the life of both the cooking zones and cookware. [. . . ] For further information relating to the correct disposal of exhausted household appliances, owners may contact the public service provided or their local dealer. 18 Care and maintenance Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Stainless steel frame (only in models with outer frame) Stainless steel can be marked by hard water which has been left on the surface for a long time, or by cleaning products containing phosphorus. After cleaning, it is advisable to rinse the surface well and dry it thoroughly. [. . . ]