User manual CHEVROLET SILVERADO 2009

[. . . ] 2009 Chevrolet Silverado Owner Manual Seats and Restraint System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 Head Restraints . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3 Front Seats . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-4 Rear Seats . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] · To ignore the incoming call, continue with the original call with no action. · Press c x to disconnect the current call and switch to the call on hold. 3-125 Three-Way Calling Three-Way Calling must be supported on the Bluetooth phone and enabled by the wireless service carrier to work. The system responds with "Ready" followed by a tone. The system responds with "Three-way call, please say dial or call". Use the dial or call command to dial the number of the third party to be called. Once the call is connected, press the callers together. To Mute a call 1. The system responds with "Ready" followed by a tone. The system responds with "Call muted". To Cancel Mute 1. The system responds with "Ready" followed by a tone. After the tone, say "Mute Call". The system responds with "Resuming call". b g to link all Transferring a Call Audio can be transferred between the in-vehicle Bluetooth system and the cell phone. Ending a Call Press c x to end a call. To Transfer Audio to the Cell Phone During a call with the audio in the vehicle: 1. The system responds with "Ready" followed by a tone. Say "Transfer Call. " The system responds with "Transferring call" and the audio will switch from the vehicle to the cell phone. Muting a Call During a call, all sounds from inside the vehicle can be muted so that the person on the other end of the call cannot hear them. 3-126 To Transfer Audio to the In-Vehicle Bluetooth System The cellular phone must be paired and connected with the Bluetooth system before a call can be transferred. The connection process can take up to two minutes after the key is turned to the ON/RUN or ACC/ACCESSORY position. During a call with the audio on the cell phone, press bg for more than two seconds. The audio switches from the cell phone to the vehicle. Dual Tone Multi-Frequency (DTMF) Tones The in-vehicle Bluetooth system can send numbers and numbers stored as name tags during a call. This is used when calling a menu driven phone system. Account numbers can be programmed into the phonebook for retrieval during menu driven calls. Sending a Number During a Call 1. The system responds with "Ready" followed by a tone. The system responds with "Say a number to send tones" followed by a tone. Say the number to send. Voice Pass-Thru Voice Pass-Thru allows access to the voice recognition commands on the cell phone. See the cell phone manufacturers user guide to see if the cell phone supports this feature. This feature can be used to verbally access contacts stored in the cell phone. [. . . ] 3-41 W Warning Lights, Gages, and Indicators . . . . . . . . . . . . . . . 3-33 Warnings DIC Warnings and Messages . . . . . . . . . . . . . . . . . . . . . . . . 3-66 Hazard Warning Flashers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-8 Safety and Symbols . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]