User manual CHICAGO 3029

[. . . ] Do not modify this product, and do not use this product for a purpose for which it was not intended. Replacement parts and accessories: When servicing, use only identical replacement parts. Only use accessories intended for use with this product. The Off Road Truck Light System is for OFF ROAD use only. [. . . ] NOTE: The Halogen Lamps may be mounted above or below the front bumper. Make sure the desired mounting location does not obstruct the vehicle's headlights or turn signals. Place the Halogen Lamps on the bumper, and mark the desired mounting locations at an equal distance from the center of the bumper. Where pre-marked, drill a 3/8" hole through the bumper. Then, mount the Halogen Lamps using the hardware provided. NOTE: Make sure no electrical wires or cables are in the way of the drilling path. (See Figure A. ) Mount the Light Switch in a location that is within easy reach (i. e. , dashboard, console). With the Light Switch in the desired position, mark the holes for drilling and drill two 1/16" holes. Then, mount the Light Switch with the Screws provided. Connect the Red Wire of the passenger side Lamp to the 4 ft. (See Figure B, next page. ) Connect the 4 ft. Red Extension Wire to the "Y" Connector of the 12 ft. (See Figure B. ) Connect the Red Wire of the driver side Lamp to the "Y" Connector of the 12 ft. (See Figure B. ) Connect the Black Ground Wire from each Lamp (using the Screws provided) to the chassis of the vehicle or any other grounded metal surface. (See Figure B. ) 3/8" HOLE FLAT WASHER LOCK WASHER NUT 5. 6. 9. FIGURE A 10. Route the 12 ft. Red Extension Wire along the vehicle's existing wiring, on the side of the engine compartment, through the existing hole in the firewall, to the previously installed Light Switch. Red Extension Wire to the Light Switch terminal #2. (See Figure B. ) Connect the Black Ground Wire to the Light Switch terminal #4 and the other end of the Black Ground Wire (using the Screws provided) to the chassis or any other grounded metal surface. (See Figure B. ) Connect one end of the Blue Power (Hot) Wire to the Light Switch terminal #1 and the other end of the Blue Power (Hot) Wire to a (+) 12 Volt power source at the fuse box or the (+) terminal of the vehicle's battery. [. . . ] Check for misalignment or binding of moving parts, cracked or broken parts, damaged Wiring, damaged Lens/ Lens Guard, and any other condition that may affect its safe operation. If a problem occurs with the Lights, have the problem corrected before further use. TO CHANGE THE 100 WATT HALOGEN BULB, open the Lens Guard and remove the Lens. Using gloves or a soft cloth, gently press the Bulb to one side of the Socket and remove the opposite end. [. . . ]