User manual CHICAGO 34552

[. . . ] Lubricate Breaker Handles (4, 5) when removing tire from rim; failure to do so can lead to property damage. Keep bystanders out of the area during use. Do not use when tired or when under the influence of drugs, medication or alcohol. Do not allow children to play with or near this item. [. . . ] Attach the end of the Forcing Handle (5) to the tab of the Locking Nut (3) using one of the Pins (6). Insert Breaker Handle (4) through the slot in Forcing Handle and attach the rubberized Grip (12) to the Breaker Handle, making sure that the finger grip end of the handle is towards the Locking Nut. To break tire beads, Breaker Handle foot should rest horizontally over the tire at edge of rim. (Use combination of adjustment holes in the Forcing Handle and Breaker Handle and if required, remove one of the Spacers). See Figure 4. Grip (12) Pin (6) Base Pin (13) Figure 1 8. 5. For temporary mounting to a vise, position the Base between vise jaws with the Base Pin accessible from the sides of the vise. Tighten vise jaws, Use vice jaw guards to prevent damage to Holder surfaces. See Figure 2. Hub Holder (16) Vise 9. Breaker Handle (4) Figure 2 remoVing tire operation 1. Remove balancing weights, if any, from rim edges. Page 2 Forcing Handle (5) Figure 4 For technical questions, please call 1-800-444-3353. SKU 34552 10. 13. Pull down on both handles until the bead slide off the rim. Remove mounting components and flip the tire off, forcing the tire off the rim. Remove Pin and remove the Forcing Handle assembly from the Locking Nut. Be sure to wear heavy-duty work gloves and to use caution when handling. Lubricate each bead with to facilitate sliding of the bead over the rim (Windex® window cleaner is a good lubricant substitute. ) Push down on tire until there is enough room to place the ball end of the Mounting/Demounting Tool (11) under the bead on the opposite end of the tire. See Figure 5. Mounting/Demounting Tool (11) 19. 21. Position the ball end of Mounting/Remounting Tool under lower bead of tire. Push down on handle to push lower bead above the rim. Pull handle of Mounting/Remounting Tool clockwise to remove bottom bead from the rim. Failure to use Bead lubricant when removing the tire from the rim may result in damage to the bead. 22. 14. 15. installing tire operation 1. To mount a new or repaired tire, lubricate the inside and outside both tire beads. Push the lower bead onto the rim as far as it will go without forcing it. See Figure 7. Figure 7 Figure 5 Base (15) 16. [. . . ] We shall in no event be liable for death, injuries to persons or property, or for incidental, contingent, special or consequential damages arising from the use of our product. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation of exclusion may not apply to you. THIS WARRANTy IS exPReSSLy IN LIeU OF ALL OTHeR WARRANTIeS, exPReSS OR IMPLIeD, INCLUDING THe WARRANTIeS OF MeRCHANTABILITy AND FITNeSS. To take advantage of this warranty, the product or part must be returned to us with transportation charges prepaid. [. . . ]