User manual CHICAGO 38391

[. . . ] 12 volt Jump-start and power supply 38391 set up and operating instructions note: after purchase and before initial use of the Jump-start, fully charge the Jumpstart battery until the dc charging led turns off. after each jump start, fully recharge the battery until the dc charging led turns off. Fully charge Jumpstart battery every 30 days to ensure long battery life. visit our website at: http://www. harborfreight. com read this material before using this product. [. . . ] When charging, first connect the red (+) clamp to the positive (+) battery terminal. Connect the negative (-) clamp to a non-moving metal engine part for negative ground systems. Only use the charger on 12 V systems on vehicles or boats. Do not use as a replacement for a vehicle battery. The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. People with pacemakers should consult their physician(s) before use. Electromagnetic fields in close proximity to heart pacemaker could cause pacemaker interference or pacemaker failure. For technical questions, please call 1-800-444-3353. Page 3 controls and components Red Clamp Jump Start ON/OFF Work Light Test Meter Black Clamp 120 v~ charging Cigarette Lighter Plug-In Power Cord (5) 1. Figure 2 Plug the Power Cord (5) into a wall outlet and plug the female end of the Power Cord into the 120V male Charging Plug of the 120V~ Charging Port (see Figure 2, above). Before first use, fully charge the Jump-start battery until the dc charging led turns off. after each jump start, fully recharge the battery until the dc charging led turns off. it may take up to 48 hours to fully charge the Jump-start battery. Check the progress by pressing the Voltage Test Switch. The level of battery power will then display on the Test Meter. Fully recharge Jump start battery every 30 days to ensure long battery life and reliability. 2. Charging Receptacle Voltage 120 V Test Charging Switch 3. Plug DC Charging Light (Male) Light Switch Figure 1 charging note: After purchase and before initial use, fully charge the Jump-Start battery until the DC charging LED turns off. The ON/Off switch (See Figure 1) regulates power to the clamps only. Keep it in the "Off" position except when jumpstarting. 4. note: The charger unit comes equipped with an automatic shut off LED to prevent overcharging. Leave the unit plugged in to make sure it is charged for emergencies. Page 4 SKU 38391 For technical questions, please call 1-800-444-3353. note: The LED light will go on (when Switch is in the OFF position) to indicate a reverse polarity condition. note: Charging room temperature: 50o F - 104o F. 12 vdc charging note: This system is equipped with a 12 VDC Cigarette Lighter Adapter so you can charge the Jump-Start from a vehicle or boat battery. [. . . ] After each jump start, fully recharge the Jump-Start battery until the DC Charging LED turns off. SKU 38391 For technical questions, please call 1-800-444-3353. Page 6 recharging using 12 vdc supply 1. Insert the Cigarette Lighter Recharger Plug into the Front Panel port labeled recharge. Insert the other end of the Cigarette Lighter Recharger Cord into the 12 VAC Cigarette lighter receptacle on your vehicle or boat. Allow the Jump Start System to recharge for 10 hours or until Charging LED turns off. [. . . ]