User manual CHICAGO 39741

[. . . ] Safety Warnings and Precautions WARNING: When using tool, basic safety precautions should always be followed to reduce the risk of personal injury and damage to equipment. Read all instructions before using this product!Do not use the Wheel Balancer until properly trained. This product is intended for use by properly trained and experienced personnel only. [. . . ] Inspect tool cords periodically and, if damaged, have them repaired by an authorized technician. The handles must be kept clean, dry, and free from oil and grease at all times. Watch what you are doing; use common sense. Do not operate any tool when you are tired. Before using any tool, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment and binding of moving parts; any broken parts or mounting fixtures; and any other condition that may affect proper operation. Any part that is damaged should be properly repaired or replaced by a qualified technician. When servicing, use only identical replacement parts. Use of any other parts will void the warranty. Only use accessories intended for use with this tool. Approved accessories are available from Harbor Freight Tools. Do not operate tool if under the influence of alcohol or drugs. Read warning labels on prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not operate the tool. Note: The warnings and instructions contained in this instruction manual cannot cover all possible conditions and situations that may occur when using this product. It must be understood that common sense and caution are factors which cannot be built into this product. These factors must be supplied by the person operating the tool. Unpacking When unpacking, check the Parts Diagram and Part Number Listing on page 5 to make sure all parts are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual. Assembling the Wheel Balancer The Wheel Balancer is easily assembled by following the steps shown below. Part numbers used below refer to the Parts Diagram and Part Number Listing on page 5. Insert the threaded end of the Shaft (#9) into the Base (#12). Use Flat Washer (#11), Lock Washer (#13) and two Nuts (#10) to tightly secure the Shaft - see the Parts Diagram for proper assembly order of hardware. #39741 For technical questions, please call 1-800-444-3353. Page 3 2. The Balancing Cone Set (#7) rests on top of the tip located on top of the Shaft (#9). [. . . ] We shall in no event be liable for death, injuries to persons or property, or for incidental, contingent, special or consequential damages arising from the use of our product. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation of exclusion may not apply to you. THIS WARRANTY IS exPReSSLY IN LIeU OF ALL OTHeR WARRANTIeS, exPReSS OR IMPLIeD, INCLUDING THe WARRANTIeS OF MeRCHANTABILITY AND FITNeSS. To take advantage of this warranty, the product or part must be returned to us with transportation charges prepaid. [. . . ]