User manual CHICAGO 40134

[. . . ] When not in use, tools must be stored in a dry location to inhibit rust. Always lock up tools and keep out of reach of children. Do not attempt to force a small tool or attachment to do the work of a larger industrial tool. There are certain applications for which this tool was designed. [. . . ] Any part that is damaged should be properly repaired or replaced by a qualified technician. Do not use the tool if any switch does not turn On and Off properly. Prevent body contact with grounded surfaces such as pipes, radiators, ranges, and refrigerator enclosures. When servicing this product, use only identical replacement parts. Use of any other parts will void the warranty. Only use accessories intended for use with this tool. Approved accessories are available from Harbor Freight Tools. Do not operate tools if under the influence of alcohol or drugs. Read warning labels on prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not operate tools. SKU 40134 Page 3 18. Use proper size and type extension cord. If an extension cord is required to power tools, it must be of the proper size and type to supply the correct current to the tool without heating up. Otherwise, the extension cord could melt and catch fire, or cause electrical damage to the tool. Most hand tools require an extension cord of 0 to 10 amps capability (up to 50 feet), with wire size rated at 18 AWG. Longer extension cords require larger size wire. If you are using the tool outdoors, use an extension cord rated for outdoor use. (signified by "WA" on the jacket). For your safety, service and maintenance should be performed regularly by a qualified technician. Note: Performance of this product may vary depending on variations in line voltage. Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. Unpacking When unpacking, check to make sure the following parts are included. (1) (2) (3) ITEM 1 2 3 4 (5) DESCRIPTION Plastic Horn, Low Tone Plastic Horn, High Tone Compressor, 12 VDC Vinyl Tubing, 30" Electric Relay, 12 VDC, 40A, 4-pole, 2-way Coupling, "Y" Tubing Screws and Nuts Mounting Blocks (6) 5 6 (4) (7) (8) 7 8 NOTE: Some parts are listed and shown for illustration purposes only and are not available individually as replacement If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual. SKU 40134 Page 4 Installation Caution: Installation should be completed by a qualified technician. [. . . ] If this is the case, refer to Wiring Diagram Positive Ground. If the Compressor turns on and the Horns do not sound, reverse the Compressor connections (+ / -). Caution: Use caution to prevent accidental short circuiting of power while performing installation. Wiring Diagram Negative Ground SKU 40134 Page 6 Wiring Diagram Positive Ground Maintenance Periodically remove the Tubing from the top of the Compressor, then add a few drops of light oil to the air outlet. Energize the unit by pressing the pushbutton. [. . . ]