User manual CHICAGO 5223

[. . . ] If unreadable or missing, contact Harbor Freight Tools for a replacement. Harbor Freight Tools is not responsible for cosmetic damages to vehicle's appearance due to improper use or lack of experience for using this type of tool. 6. visit our website at: http://www. harborfreight. com 7. read all precautions and instructions. Copyright© 2009 by Harbor Freight Tools®. No portion of this document or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. [. . . ] Clamp the Jaws onto the object to be pulled. Turn Lock Nut (3) clockwise against the end of the Jaws, forcing them apart, causing the claws to be pushed inward against the work piece. Push the Slide Hammer towards the work-piece, and then forcefully pull it back towards the cross par end. Repeat as needed, and adjust the required force based on job requirement or your physical ability. 5. 4. 6. 5. Jaw operation or extraction (internal grip) Rear Axle Puller (2) 1. 2. Attach the conic end of the Lock Nut (3) onto the Spindle. Depending on the application or requirement, use the Screws and Nuts to attach the Jaws to the SKU 5223 Figure 2 Page 2 For technical questions, please call 1-800-444-3353. 2 or 3 Jaw Puller Adapters (6 or 10). Thread the adapter onto the Spindle until non-threaded end of the Spindle exits the Adapter. Spindle (11) 5. Thread the Spindle into the Dent Puller Adapter. Thread the Lock Nut (3) against the Dent Puller Adapter and hand tighten. Push the Slide Hammer toward the object to be pulled. Gently pull the Slide Hammer toward the Handle Cross Bar. Do not use excessive force when pulling dents. Repeat Step 5 until dent has been pulled out. 6. 7. 8. 3-Jaw Puller Adapter (10) Lock Nut (3) Jaws (4) operation (hook/thread pulling) 1. Identify the lip area you will be inserting the Pull Hook (5) into or onto. Thread the Puller Hook onto the end of the Slide Screw. See Figure 6. Lock Nut (3) Puller Hook (5) Screw and Nut (1) Figure 4 3. 4. To grip the work piece internally, claws of the Jaws should be facing outward. Back-off the Lock Nut (3) to permit the jaws to be attached to the workpiece. Turn the Lock Not forward, causing the claws to expand and grip the work piece firmly. Push the Slide Hammer towards the work-piece, and then forcefully pull it back towards the cross par end. Repeat as needed, and adjust the required force based on job requirement or your physical ability. 5. Figure 6 operation (dent pulling) 1. Attach hollow end of the Lock Nut onto Spindle. [. . . ] Proof of purchase date and an explanation of the complaint must accompany the merchandise. If our inspection verifies the defect, we will either repair or replace the product at our election or we may elect to refund the purchase price if we cannot readily and quickly provide you with a replacement. We will return repaired products at our expense, but if we determine there is no defect, or that the defect resulted from causes not within the scope of our warranty, then you must bear the cost of returning the product. This warranty gives you specific legal rights and you may also have other rights which vary from state to state. [. . . ]