User manual CHICAGO 66771

[. . . ] TAG-ALONG TrAiLer 66771 SeT up, OperATiNG, ANd ServiciNG iNSTrucTiONS WARNING!IMPORTANT INFORMATION This Tag-Along Trailer's Hitch Coupler MUST be properly secured to the hitch ball of the towing vehicle. After assembly and attachment, pull up and down on the Hitch Coupler to make sure the hitch ball is fitting snugly in the Hitch Coupler. There must be no play between the hitch ball and Hitch Coupler. [. . . ] NOTe: To reduce friction between the ball hitch and the hitch coupler (not supplied), apply a layer of heavy weight grease over the hitch ball. 1. OperATiONAL dO'S ANd dON'TS dON'T: This Tag-Along Trailer was not designed for use in commercial applications. dO: Make wide turns when towing a loaded Tag-Along Trailer avoiding sharp turns, and U-turns. Turning too sharply can cause damage to the Trailer and/or the tow vehicle. dON'T: Never ATTempT TO BAcK A LOAded TAG-ALONG TrAiLer. This can overstress the Trailer and possibly bend the Frame. dO: Before each use, check the Lug Nuts for tightness and security. dO: Before towing, always check tire pressure. dO: Always check tire pressure on the tow vehicle before using. Check the manufacturer's manual for the tow vehicle you are using. dO: Always hitch the Tag-Along Trailer to the tow vehicle before loading the items to be towed. dO: ALWAYS LOAD THE TAGALONG TRAILER BEING TOWED FACE FORWARD. Make sure the Upper Shell (14) is locked, the Key is in a secure location and the Trailer is secure before towing. 2. Insert a ball mount into the Coupler 2. and secure in place using the Safety Chains (8). if the coupler coupler is not secured properly, the ball mount could come loose while the Tag-Along Trailer is 3. in motion, possibly causing property damage, SeriOuS perSONAL iNJurY ANd/Or deATH!Make sure the Safety Chains are secured safely to the Trailer and the tow vehicle. Do not let the Safety Chains come in contact with the ground while towing the railer. Connect the Tail Light wiring to the tow vehicle, then test all functions (turn signals, on/off status, and brake lights) after connecting, and before towing. The blue and white wires plug into the Tail Lights by pushing them through the existing holes on the back of the Lights. To remove them, push a large paper clip through one of the holes to remove the spring tension and pull the wires out. At the front of the Trailer the wires are contained inside a female electrical plug that connects to a male outlet on the tow vehicle. [. . . ] Continue doing this until every slot in the Bearing is completely full of grease. As you finish assembling the Hub, be careful not to get any dirt or debris on any part of the assembly. Replace the Dust Hub Cap over each Bearing. 3. SKU 66771 For technical questions, please call 1-800-444-3353. Page 16 maintenance chart 1. The following Chart serves as a basic guideline for scheduling your trailer maintenance. [. . . ]