User manual CHICAGO 66786

[. . . ] 20 gallon PoRTaBlE oil lifT dRain 66786 SET uP and oPERaTing inSTRucTionS distributed exclusively by Harbor freight Tools®. 3491 Mission Oaks Blvd. , Camarillo, CA 93011 Visit our website at: http://www. harborfreight. com Read this material before using this product. failure to do so can result in serious injury. SaVE THiS manual. Copyright© 2009 by Harbor Freight Tools®. [. . . ] If used oil does not evacuate the Tank (23) upon pressurization, check to make sure the Ball Valve (6) is fully closed with the Handle (10) in the horizontal position. If this does not correct the problem, remove the unit from service immediately and contact a qualified service technician for repair. WARNING: The brass components of this product contain lead, a chemical known to the State of California to cause birth defects (or other reproductive harm). (California Health & Safety code § 25249. 5, et seq. ) 13. Only use with accessories rated to handle the forces exerted by this tool during operation. Other accessories not designed for the forces generated may break and forcefully launch pieces. SKU 66786 SaVE THESE inSTRucTionS. for technical questions, please call 1-800-444-3353. Page 5 funcTional dEScRiPTion Specifications Capacity Operating Air Pressure Air Inlet 20 Gallons 10 PSI 1/4" -18 NPT assembly 1. Be sure to assemble Oil Lift Drain on flat, level surface able to support weight of tool. To begin assembly, slide one Fixed Wheel (18) onto each end of the axle of the Tank (23). Lock Wheels into place using Washers (17) and Retaining Rings (16). If the Casters are not already attached to the Tank, fasten one Swivel Caster (22) to each plate located on the base of the Oil Lift. Slide on Spring Washer (20), Washer (21), and then thread Locking Nut (19) onto Caster stem to secure Swivel Casters in place. Insert the Handle (10) into the slot on the upper side of the Tank (23). Insert the Bushing (4) into the Nut (5) and thread the Nut into the Ball Valve until secure. When tightening, make sure the Lock Knob (3) is parallel with the handle of the Gate Valve (6). Thread the Bowl (1) into the Drain Tube (2) until fastened securely. Insert the Drain Tube, with the Bowl fastened to the other end, into the Bushing. Select the required height and lock Drain Tube in place using the Locking Knob (3). See assembly diagram on page 12. 2. iniTial Tool SET uP/ aSSEmBlY Read the EnTiRE imPoRTanT SafETY infoRmaTion section at the beginning of this manual including all text under subheadings therein before set up or use of this product. note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual. 3. 4. unpacking When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at 1-800-444-3353 as soon as possible. [. . . ] Have qualified technician inspect internal mechanism and replace parts as needed. Check for incorrect alignment and uneven gaps. If cross-threaded, disassemble and replace damaged parts before use. If housing cannot tighten properly, internal parts may be misaligned. [. . . ]