User manual CHICAGO 90589

[. . . ] SEMI-AUTOMATIC WITH SWINGING ARM TIRE CHANGER Model 90589 ASSEMbly ANd OpERATING INSTRUCTIONS Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly from the product described herein. distributed exclusively by Harbor Freight Tools®. 3491 Mission Oaks Blvd. , Camarillo, CA 93011 Visit our website at: http://www. harborfreight. com For technical questions or replacement parts, please call 1-800-444-3353. Manual revised 07g Copyright© 2003 by Harbor Freight Tools®. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. Read this material before using this product. [. . . ] Maintain a firm grip on the Knob (115) while compressing the Spring. Firmly tighten the Screw (114) to secure the Knob to the Vertical Arm. 13. REV 07g SKU 90589 For technical questions, please call 1-800-444-3353. Page 9 14. Re-attach the Plastic Cover (116), and re-tighten the three Screws (113 & 129). If using wooden blocks to support the Vertical Arm (120), remove the blocks. (See Figure b-2. ) NOTE: For shipping purposes, the Shovel (315) is restrained with a temporary tie-down bracket. Make sure to remove and discard the bracket. (See Figure A. ) Lay out the Tool Box (IT42) and Tool Box Support (IT38). diagram. ) Attach the Tool Box Support (IT38) to the Body (1) of the Tire Changer, using the Mounting Bracket Bolts. diagram. ) Attach the Tool Box (IT42) to the Tool Box Support (IT38), using the Mounting Bracket Bolts. diagram. ) Remove the Left Side Cover (8) from the Body (1) to expose the inside of the Tire Changer. diagram. ) Run the Hose (IT15) through the opening in the Body (1) of the Tire Changer. Then, connect the Hose to the 5-Way Valve (IT17). diagram. ) Re-attach the Left Side Cover (8) to the Body (1) of the Tire Changer. diagram. ) Assembly of the Tire Changer should be complete and the machine now ready to operate. Only set up and use the Tire Changer on a flat, level surface that is capable of supporting the weight of this heavy tool (566 lb. ) and all required tools and tires. 15. 16. 22. OpERATING INSTRUCTIONS To perform preliminary Operating Tests: 1. Plug the Power Cord into the nearest 220 volt, grounded, electrical outlet. Connect the air compressor's supply hose (not included) to the Filter & Pressure Reducer + Lubr. Set the air compressor's regulator to no more than 110 PSI. Turn on the air compressor, and allow sufficient time for adequate build-up of compressed air. (See Figure A. ) Depress the Reverse Pedal (401) down. The Turntable (201) should turn in a clockwise direction. [. . . ] Clean the 5Way Valve, using a jet of compressed air. Or if necessary, replace the unit and reattach air hoses to 5-Way Valve. (See Figure I. ) TROUblESHOOTING GUIdE 1. The Power Plug is not inserted in its electrical outlet or no power from the main electrical supply source. [. . . ]